B38A15 engine faults.

Plastic guide rails hold the timing chain in place. On these engines the plasticiser in the plastic leaches out over time, the rail turns brittle and then breaks into pieces. The pieces land around the chain and further down, in the oil sump and on the strainer of the oil pump, and the leached plasticiser also deposits on that strainer. Two kinds of damage come from this: without its guide the chain starts to flap, and less oil reaches the engine through the narrowing strainer. The first sign is a rattling noise on a cold start that goes quiet after a few seconds or once the engine has warmed up. It is heard best on a fully cold start in the morning, because the chain tensioner needs time to tension the chain. The problem is reported above 60,000 km. Replacing the chain costs between 700 and 2,900 euro, and is typically four figures, because the chain can only be reached by removing several engine components.

In these engines the water pump is not belt driven but has its own electric motor. It gains on fuel consumption, but it opens a new failure path: the pump or its electronics often simply stops with no warning. Measured in the official complaints, the typical mileage is 161,000 km (a tenth of the complaints already at 81,000, a tenth only above 257,000 km). So the common wisdom of "around 100,000 km" is early: most of the failures happen between 130,000 and 250,000 km.