vinkodex.
Engine code

CBDC engine faults.

Listed as: 2.0 TDI (CR), 2.0 TDI, 2.0 TDI (119g). The faults belong to this engine code. They do not apply to every car with that name.

diesel

fuel

1968 cc

displacement

81 kW (110 HP)

power

2 fault write-ups. Both are important.

Before you buy

Known faults

2 important faults

critical1

On these engines the oil pump is driven by its own small toothed belt, and that belt runs in the hot engine oil. This is not the large timing belt that drives the camshafts, it is a separate belt in the lower part of the engine. In the oil the rubber hardens over time, its surface starts to crumble, and the loose particles block the suction side of the oil pump, so the oil pressure drops. If the belt snaps, the oil pump stops at once and the engine is left without lubrication within seconds. The rubber crumbs can also ruin the turbocharger and the camshaft adjuster, because they are lubricated from the same oil circuit. The maker specifies no replacement interval for this belt, so most cars still carry the one fitted at the factory, and the failures are reported above 150,000 km. Oil outside the specification and a stretched oil change speed the process up, because this belt ages in the oil. Replacing the belt itself costs between 200 and 600 euro, as long as the engine has not run without oil pressure.

above 150,000 km200–600 EUR

What to check

  • Ask whether the oil pump belt has been replaced, and if so at what mileage
  • Unscrew the oil filler cap and look for black rubber crumbs in the lubricant
  • Ask which oil was used and how often the engine was serviced
2 more steps in the write-up

expensive1

The internal springs of the flywheel tire, and the two discs knock against each other. The signs are a rattling or knocking from the bellhousing at idle and when releasing the clutch pedal, and vibration through the floor. If the clutch slips without a burnt smell, that also points to the flywheel. It is worth replacing in time: a disintegrated flywheel can destroy the bellhousing too. At a clutch replacement the two go together anyway.

What to check

  • At idle, without touching the clutch pedal, listen for the rattle from the bellhousing, then press the pedal: if it stops, that is suspect
  • Watch for the characteristic clatter on starting and switching off
  • Put your foot on the floor at idle: a noticeable vibration indicates tired springs
2 more steps in the write-up

Engine code

Factory data

Factory data

Engine family
—
Fuel
diesel
Displacement
1968 cc
Power
81 kW (110 HP)
Production
—

Generations

Which models it is fitted to

4 generations.

Information, not an expert opinion

We write the descriptions, and we put the source next to them. A person reviews them before they go out. They are still information, not a technical expert opinion.

  • A fault on the list does not mean the car you are looking at has it.
  • A fault missing from the list does not mean the model is fault-free. Write-ups are made model by model. Not all of them are done.
  • You decide whether to buy. This is no substitute for an inspection. That needs a workshop and a history check.
Details in the terms