Valvetronic adjusts the lift of the intake valves, and an eccentric shaft does that work. Three parts can fail here, at very different prices, and their symptoms are nearly identical.

The sensor is usually the first to give up: oil leaks past its seal into the connector, and the oil corrupts the signal the engine control unit depends on. From then on the control unit gets no reliable position feedback, cannot set the valve lift precisely, and switches to a protective strategy. The fault code in this case is a plausibility fault, 2A67 or 2A6B: the control unit does not consider the position signal credible.

The eccentric shaft itself can also wear out or seize, and there are several causes for that: lack of lubrication from oil sludge and skipped oil changes, wear of the bearings, a system driven on with a failed actuator motor, and overheating and oil contamination in the cylinder head. It is reported from 150 000 kilometres.

The symptom is similar in all three cases: an unstable idle, stumbling and long cranking at a cold start, a check engine light that comes on and goes out on its own, lack of power or limp mode, inconsistent throttle response, and misfires cylinder by cylinder. A clicking, binding noise from the engine bay points to a seizing shaft.

The misdiagnosis is common, because the symptom shows up at combustion, so coils and spark plugs are suspected first, while the fault is in the air control. The condition of the shaft can only be established after the valve cover has been removed and it has been inspected. The sensor connector, though, is worth opening up first: if it is oily, that is the far cheaper route.