In these engines the oil pump is adjustable, and the factory setting deliberately keeps the oil pressure low at low revs to reduce the drag of driving it. At low revs the stock pump works at around 1.8 bar, up to 2 bar at most. With a warm engine at idle this can fall further, and values below 1 bar have been reported. The camshaft adjusters feel the low pressure first, because the oil pressure itself is what holds the adjuster in place: this is where the clacking noise heard at idle comes from. The chain tensioner follows, which the same pressure tensions, and the timing chain therefore wears faster. The reference values for this engine family are 2 bar at idle, 3 bar at 2,000 rpm and 4.5 bar at 4,000 rpm. The turbocharger and the camshaft are lubricated from the same circuit. A strengthened oil pump raises the idle pressure by about 20 per cent. Repairing the pump costs between 800 and 2,800 euro, and replacing a worn chain is a further 1,200 to 3,500 euro.

The 7 speed, wet clutch DSG that replaced the DQ250 in the MQB models (0GC / DQ381) is vulnerable from the mechatronics side. Typical faults are a harsh 2 to 3 shift, delayed D/R engagement and limp mode; a fault in the clutch position sensors gives a separate group of codes.

The combined housing of the water pump and the thermostat is plastic, and it is bolted directly to the hot engine block. The many heat and cool cycles warp it, it becomes brittle, and then it develops a hairline crack: the fault is almost always the housing, not the pump itself. The signs are slowly disappearing coolant with no visible puddle, the coolant level light, a sweet smell from the engine bay, and later a pink stain under the car. The repair means replacing the pump and the housing together, and the intake manifold has to come off for it: 4 to 6 hours of work. It shows up on model years 2015 to 2025.

With direct injection the fuel does not wash the intake valves: the petrol goes into the cylinder, not behind the valve. The oil mist and soot arriving through the EGR and the crankcase ventilation therefore build up on the valve stem and head, and from 80,000 to 100,000 km they restrict the flow. Symptoms are hesitation, loss of power, a rough cold start and misfire. It is not a part failure: it is a consequence of the design, and therefore it comes back. Cleaning (walnut or dry ice blasting) helps for a few tens of thousands of kilometres.

On the MQB evo generation the MIB3 touchscreen freezes, restarts on its own, and sometimes stays black. In the What Car? survey, 59 per cent of 8Y A3 owners reported a fault, and 44 per cent of those concerned the infotainment. Volume and temperature are set on touch sliders instead of physical buttons, and if the system hangs you cannot adjust them while driving either.

The dash shows "Error: Workshop! Only leave vehicle in position P" with an audible warning. The message appears in whatever language the car is set to, for example "Fehler: Werkstatt! Fahrzeug nur in Stellung P verlassen" in German.