vinkodex.

Audi A6 2.0 TDI 136hp common faults.

2011–2014, saloon, diesel, 136 HP.

The fault list covers: CGLE, CSUE engine, 0AW transmission.

What you save stays on this device only. My saves

5 fault write-ups. 4 important. 2 recalls.

If you know the year, pick it. Faults for other years drop out of the list.

Before you buy

Known faults

4 important faults

critical1

Multitronic (continuously variable CVT): jerking, control unit, chain

critical

The continuously variable gearbox of the longitudinal engine Audis (Multitronic) is vulnerable from both the control unit and the drive chain side. Symptoms are jerking and slipping under acceleration, delayed engagement, limp mode, and in extreme cases a total loss of drive.

Show the rest

The cost of a rebuild can account for a significant part of the value of the car, and a faulty car often goes up for sale in a "it still runs, it just jerks now and then" condition. On the same model the manual or tiptronic sibling is a significantly lower risk.

What to check

  • Standing still on the brake, shift between D and R: an engagement taking longer than 1 to 2 seconds is suspect
  • Pull away gently, then on half throttle: there must be no jerking, slipping or flaring of the revs
  • A longer, warm test drive is mandatory: the fault typically appears once warmed up
2 more steps in the write-up

expensive3

Air suspension: compressor, air spring, ride height sensor

expensive

The four groups of parts in the air suspension (compressor, valve block, ride height sensors, air springs) work together, and any weak link causes a fault message, an uneven ride height or a car that settles. The characteristic symptom: the car sits down on one corner overnight, levels itself for minutes in the morning, and the compressor runs long and loud. According to the reports the compressor lasts 80,000 to 100,000 km; and a leaking air spring takes the compressor with it, because it keeps trying to make up the loss.

What to check

  • Look at the car cold, after standing a long time: has it settled on any corner
  • After startup time how long it takes to level, and listen to the compressor
  • Cycle through the ride height settings in the onboard menu and check that all of them work
3 more steps in the write-up

Dual mass flywheel: diesel

expensive

The internal springs of the flywheel tire, and the two discs knock against each other. The signs are a rattling or knocking from the bellhousing at idle and when releasing the clutch pedal, and vibration through the floor. If the clutch slips without a burnt smell, that also points to the flywheel. It is worth replacing in time: a disintegrated flywheel can destroy the bellhousing too. At a clutch replacement the two go together anyway.

What to check

  • At idle, without touching the clutch pedal, listen for the rattle from the bellhousing, then press the pedal: if it stops, that is suspect
  • Watch for the characteristic clatter on starting and switching off
  • Put your foot on the floor at idle: a noticeable vibration indicates tired springs
2 more steps in the write-up

TDI: the vanes of the variable geometry (VNT) turbo stick

expensive

The vanes of the variable geometry turbo are glued together by soot and oil arriving through the EGR. First you get overboost or a lack of boost, then loss of power above 2,000 rpm, and finally limp mode. Caught in time it is enough to remove the turbo, clean it and fit a new actuator rod. Short urban trips and gentle, low rev driving speed up the deposits.

What to check

  • On the motorway, load it above 2,000 rpm: does it pull evenly, or does the power break up
  • Watch whether the warning light flashes up under acceleration (overboost protection)
  • Ask what kind of journeys it did: a daily short urban run is the worst
1 more steps in the write-up

comfort1

Coolant temperature sensor (G62) failure

comfort

The G62 sensor tells the engine control unit how hot the coolant is. If it is faulty, the control unit thinks a warm engine is cold, and runs it rich: hard warm or cold starting, a rough idle, markedly increased fuel consumption, and a dash temperature gauge that jumps around or never reaches its usual reading. The part is cheap and can be replaced in half an hour: the trouble is that many people do not recognise it and replace an injector or a lambda sensor instead. If the fault persists, the rich mixture can destroy the catalytic converter too.

What to check

  • Warm it up and watch the dash temperature gauge: the needle should sit steadily at the middle reading, not jump around
  • Watch a cold start, then a warm start after twenty minutes standing
  • With a code reader look for the 17664 / P1256 code in the engine control unit
2 more steps in the write-up

Checklist

Audi A6 2.0 TDI 136hp

First what you would check on any car. Then the faults of this model.

Before you buy

Checklist

The printed sheet starts with what you would check on any car. What you tick stays on this device only.

On every car

Ask the owner

Faults of this model

vinkodex.com · Before you buy it, see what can go wrong.

Official recall2 recallsShow

The manufacturer fixes these for free at a franchised dealer. Ask with the VIN whether it was done.

A12/0713/17Safety recallFireno date · EU Safety Gate

The additional coolant pump can block due to foreign particles in the cooling system. This can result in the pump overheating which could lead to a fire.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

A12/0942/18Safety recallFireno date · EU Safety Gate

The auxiliary coolant pump may seize up. This could lead to the pump overheating after the engine has been switched off with the risk that the vehicle could catch fire.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

Engine and transmission

2 engines · 1 transmissions

CGLE · 2.0 TDI

100 kW (136 HP) · diesel

0AW · multitronic, continuously variable (CVT)

CVT · —

Torque limit400 Nm
MakerAudi/LuK

We built the code from the model and the gear count. The factory sheet does not state it. More than one engine code is possible. The fault list shows the faults of each.

Variant data

What is in this version

Factory data

Trim
—
Body
saloon
Fuel
diesel
Transmission
automatic
Engine size
1968 cc
Power
100 kW (136 HP)
Drive
FWD
Production
2011–2014

Factory service interval

The manufacturer specifies this for this version. Of the mileage and the time, the one that comes first is the one that counts.

  • Air filter

    • 60,000 km or 4 years

  • Cabin (pollen) filter

    • 30,000 km or 2 years

  • Engine oil and oil filter

    • LongLife30,000 km or 2 years(valid only with LongLife-approved oil)
    • 15,000 km or 1 year

  • Brake fluid change

    • first: 3 years, then 2 years(first change at 3 years, then every two years)

  • Timing belt, 1.6 / 2.0 TDI (EA188/EA189/EA288)

    • 210,000 km(EA288, including the 1.6 TDI, with no time limit. 130,000 miles = 209,215 km. Parts maker repair specification, read by a human. The interval chart at https://www.rwcmotorsport.com/tech/tdi-maintenance.php gives the same figure independently.)

  • Coolant (antifreeze) change

    • first: 193,000 km or 10 years, then 97,000 km or 5 years(G13 / G12++: first change at 120,000 miles or 10 years, then every 60,000 miles or 5 years)

  • Fuel filter, diesel

    • 60,000 km or 2 years
All C7 versions

Information, not an expert opinion

We write the descriptions, and we put the source next to them. A person reviews them before they go out. They are still information, not a technical expert opinion.

  • A fault on the list does not mean the car you are looking at has it.
  • A fault missing from the list does not mean the model is fault-free. Write-ups are made model by model. Not all of them are done.
  • You decide whether to buy. This is no substitute for an inspection. That needs a workshop and a history check.
Details in the terms