vinkodex.

Audi S8 Audi S8 common faults.

2020–2022, saloon, petrol, 571 HP.

The list covers this version.

What you save stays on this device only. My saves

1 fault write-ups. Important. 4 recalls.

If you know the year, pick it. Faults for other years drop out of the list.

Before you buy

Known faults

1 important faults

Air suspension: compressor, air spring, ride height sensor

expensive

The four groups of parts in the air suspension (compressor, valve block, ride height sensors, air springs) work together, and any weak link causes a fault message, an uneven ride height or a car that settles. The characteristic symptom: the car sits down on one corner overnight, levels itself for minutes in the morning, and the compressor runs long and loud. According to the reports the compressor lasts 80,000 to 100,000 km; and a leaking air spring takes the compressor with it, because it keeps trying to make up the loss.

What to check

  • Look at the car cold, after standing a long time: has it settled on any corner
  • After startup time how long it takes to level, and listen to the compressor
  • Cycle through the ride height settings in the onboard menu and check that all of them work
3 more steps in the write-up

Checklist

Audi S8 Audi S8

First what you would check on any car. Then the faults of this model.

Before you buy

Checklist

The printed sheet starts with what you would check on any car. What you tick stays on this device only.

On every car

Ask the owner

Faults of this model

vinkodex.com · Before you buy it, see what can go wrong.

Official recall4 recallsShow

The manufacturer fixes these for free at a franchised dealer. Ask with the VIN whether it was done.

Most recent: 24 February 2021

21V111000ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM)ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM)24 February 2021 · NHTSA (USA)

Volkswagen Group of America, Inc. (Audi) is recalling certain 2019-2021 Audi A8 and 2020-2021 Audi S8 vehicles. A missing sealing pin may allow moisture to enter the engine control module connector, possibly causing a control module malfunction.

Risk: An engine control module malfunction may cause the engine to stall, increasing the risk of a crash.

Remedy: Audi will notify owners, and dealers will inspect the engine control module connector for a missing sealing pin, and install it, if necessary. The connector will also be inspected for corrosion, and replaced as necessary. Repairs will be performed free of charge. The recall began March 12, 20121. Owners may contact Audi customer service at 1-800-253-2834. Audi's number for this recall is 97EV.

The authority's notice

A12/00504/22Safety recallInjuriesno date · EU Safety Gate

Alteration of the rear axle’s toe and/or camber values lead to increased and uneven wear on the rear tyres, and if worn down to its carcass may suffer a sudden loss of pressure. This can lead to loss of traction and may affect vehicle handling, increasing the risk of an accident. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

INFO/00138/21Safety recallInjuriesno date · EU Safety Gate

The nuts on the eccentric bolt of the rear-axle spring-link control arm may break due to stress corrosion. As a result, the rear axle could move in the wrong direction, in an uncontrollable manner at high speeds.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

SR/03859/25Safety recallFireno date · EU Safety Gate

The cell modules of the high-voltage battery could overheat during charging which can lead to a fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

Engine and transmission

No engine and transmission for this yet. When they are in, you see them here.

Variant data

What is in this version

Factory data

Trim
Audi S8
Body
saloon
Fuel
petrol
Transmission
automatic
Engine size
3996 cc
Power
420 kW (571 HP)
Drive
AWD
Production
2020–2022

Factory service interval

The manufacturer specifies this for this version. Of the mileage and the time, the one that comes first is the one that counts.

  • Engine oil and oil filter

    • LongLife30,000 km or 2 years(valid only with LongLife-approved oil)
    • 15,000 km or 1 year

  • Air filter

    • 60,000 km or 4 years

  • Brake fluid change

    • first: 3 years, then 2 years(first change at 3 years, then every two years)

  • Coolant (antifreeze) change

    • first: 193,000 km or 10 years, then 97,000 km or 5 years(G13 / G12++: first change at 120,000 miles or 10 years, then every 60,000 miles or 5 years)

  • Cabin (pollen) filter

    • 30,000 km or 2 years
All D5 versions

Information, not an expert opinion

We write the descriptions, and we put the source next to them. A person reviews them before they go out. They are still information, not a technical expert opinion.

  • A fault on the list does not mean the car you are looking at has it.
  • A fault missing from the list does not mean the model is fault-free. Write-ups are made model by model. Not all of them are done.
  • You decide whether to buy. This is no substitute for an inspection. That needs a workshop and a history check.
Details in the terms