vinkodex.

SEAT Alhambra 2.0 TDI 150hp Business Intense common faults.

2015–2019, MPV, diesel, 150 HP.

The fault list covers: CUVC, DLTB engine, DQ250 transmission.

What you save stays on this device only. My saves

8 fault write-ups. 6 important. 1 recalls.

If you know the year, pick it. Faults for other years drop out of the list.

Before you buy

Known faults

6 important faults

critical1

Rising oil level: interrupted particulate filter regeneration

critical

On short urban trips the particulate filter cannot burn through. The engine control unit then injects extra fuel late in the cycle to heat the filter, and part of that fuel passes down the cylinder wall into the sump. The oil level rises, the oil thins out, and it lubricates worse.

Show the rest

The maker addresses this itself. Audi's 2015 service bulletin (01-15-18) tells the technician how to read the oil level on 2.0 TDI engines, because an overfilled level triggers an oil change message with no engine warning light and no stored fault code.

An oil level above the maximum calls for an immediate oil change, and it points to short urban trips. A diesel driven only in town is a bigger risk from both the particulate filter and the turbo.

A thinned, rising oil level is one precondition of a runaway engine. A diesel controls torque with the quantity of fuel injected, and it has no throttle. So if enough combustible liquid reaches the intake, the engine starts running on its own oil, and cutting the injection or switching off the ignition will not stop it. The revs climb on their own until the engine destroys itself.

A raised oil level alone is rarely enough for this. The classic trigger is a failed turbo shaft seal that feeds oil mist into the intake. But the two go together: thinned oil lubricates worse, and poorer lubrication damages the turbo bearing first.

If it happens while driving, the key does not help. Only cutting off the air does: cover the intake, discharge a dry powder extinguisher into the intake tract, or on a manual select a high gear with the parking brake on and release the clutch quickly.

What to check

  • Pull the dipstick with a cold engine on level ground: the level must not be above the maximum mark
  • Smell the oil on the dipstick: a diesel smell means it is thinned with fuel
  • Ask whether the dash has ever shown an oil level sensor or oil change message
5 more steps in the write-up

expensive5

AdBlue / SCR: NOx sensor and crystallising dosing valve

expensive

On AdBlue (SCR) diesels the NOx sensor after the catalyst ages, and the tip of the dosing valve crystallises. An AdBlue warning appears on the dash, often with a countdown ("X km of starts remaining"), while the tank is full. Crystallisation typically forms with short trip, urban use, or from poor quality AdBlue; on a car standing below freezing the circuit can freeze up too.

Show the rest

At the end of the countdown there is a start inhibit: the car can become undriveable until it is repaired. The fault is not always the SCR catalyst: the cause is the sensor or the dosing valve.

between 100,000 and 160,000 km

What to check

  • Check whether there is an AdBlue filler (next to the fuel cap or in the boot): if there is not, this car does not have the system
  • Read all the dash messages after switching the ignition on: there should be no AdBlue warning and no km countdown
  • Ask for a fault code read: the codes P20EE, P2202 and P229F belong here. A cleared code comes back after a few tens of kilometres
2 more steps in the write-up

DQ250 (6 speed wet DSG): mechatronics and clutch pack

expensive

The solenoids of the mechatronics unit wear out: slow or harsh shifting, then limp mode. A characteristic sign is the partial or complete loss of reverse. Wear of the clutch pack or the wrong spring force causes jerking and slipping. Because of the wet design it fails less often and at higher mileage than the dry DQ200, but when it does fail, it is expensive.

above 150,000 km

What to check

  • Pull away slowly from standstill and watch how smooth the 1 to 2 and 2 to 3 shifts are
  • Select reverse several times, cold and warm: is it delayed, does it engage at all
  • Under load (on a slope) watch whether the clutch slips
2 more steps in the write-up

Dual mass flywheel: diesel

expensive

The internal springs of the flywheel tire, and the two discs knock against each other. The signs are a rattling or knocking from the bellhousing at idle and when releasing the clutch pedal, and vibration through the floor. If the clutch slips without a burnt smell, that also points to the flywheel. It is worth replacing in time: a disintegrated flywheel can destroy the bellhousing too. At a clutch replacement the two go together anyway.

What to check

  • At idle, without touching the clutch pedal, listen for the rattle from the bellhousing, then press the pedal: if it stops, that is suspect
  • Watch for the characteristic clatter on starting and switching off
  • Put your foot on the floor at idle: a noticeable vibration indicates tired springs
2 more steps in the write-up

Powered tailgate: erratic operation

expensive

The powered tailgate often fails: it does not respond at all, opens only halfway, or stops while moving. The repair is replacing the drive motor or the control unit.

What to check

  • Open and close the powered tailgate five times, from the button and the key
  • Watch whether it stops halfway or reverses
  • Try it by hand too: a door that moves stiffly points to the gas strut
1 more steps in the write-up

TDI: the vanes of the variable geometry (VNT) turbo stick

expensive

The vanes of the variable geometry turbo are glued together by soot and oil arriving through the EGR. First you get overboost or a lack of boost, then loss of power above 2,000 rpm, and finally limp mode. Caught in time it is enough to remove the turbo, clean it and fit a new actuator rod. Short urban trips and gentle, low rev driving speed up the deposits.

What to check

  • On the motorway, load it above 2,000 rpm: does it pull evenly, or does the power break up
  • Watch whether the warning light flashes up under acceleration (overboost protection)
  • Ask what kind of journeys it did: a daily short urban run is the worst
1 more steps in the write-up

comfort1

Coolant temperature sensor (G62) failure

comfort

The G62 sensor tells the engine control unit how hot the coolant is. If it is faulty, the control unit thinks a warm engine is cold, and runs it rich: hard warm or cold starting, a rough idle, markedly increased fuel consumption, and a dash temperature gauge that jumps around or never reaches its usual reading. The part is cheap and can be replaced in half an hour: the trouble is that many people do not recognise it and replace an injector or a lambda sensor instead. If the fault persists, the rich mixture can destroy the catalytic converter too.

What to check

  • Warm it up and watch the dash temperature gauge: the needle should sit steadily at the middle reading, not jump around
  • Watch a cold start, then a warm start after twenty minutes standing
  • With a code reader look for the 17664 / P1256 code in the engine control unit
2 more steps in the write-up

cheap repair1

DSG selector lever: failure of the P position switch

cheap repair

The dash shows "Error: Workshop! Only leave vehicle in position P" with an audible warning. The message appears in whatever language the car is set to, for example "Fehler: Werkstatt! Fahrzeug nur in Stellung P verlassen" in German.

Show the rest

The message points at the gearbox, but the fault is not there. A tiny switch sits in the module under the selector lever and signals that the lever is in park (P). Its contact wears and can also burn. That makes the signal unreliable, and the car warns you. The fault codes appear as 617752, P173400 or B116229.

At first it is intermittent. Sometimes the message comes up, sometimes not, so a short test drive easily misses it. Later it becomes permanent, and the gearbox can drop into limp mode.

This fault looks more expensive than it is. The maker released a separate retrofit switch kit for it (5Q0713128A for the black module, 3Q0713128 for the white one), which can be fitted in half an hour. The kit costs 70 to 100 pounds. At a franchised dealer, however, the whole selector lever module sometimes gets replaced, which costs 626 to 1,000 pounds there. So the difference between the two routes is roughly tenfold.

The affected group is post 2013 MQB platform Volkswagen, Audi, Seat and Skoda cars with a DSG gearbox. The switch is in these gearboxes, because that is what these cars have in common. The part itself is not part of the gearbox but of the module under the lever.

What to check

  • Watch the dash after starting: the message is intermittent and can be missed on a short loop
  • Move the lever from P to D and back several times, then get out and lock the car
  • Ask whether the selector lever switch has been replaced already, and ask for the invoice
2 more steps in the write-up

Checklist

SEAT Alhambra 2.0 TDI 150hp Business Intense

First what you would check on any car. Then the faults of this model.

Before you buy

Checklist

The printed sheet starts with what you would check on any car. What you tick stays on this device only.

On every car

Ask the owner

Faults of this model

vinkodex.com · Before you buy it, see what can go wrong.

Official recall1 recallsShow

The manufacturer fixes these for free at a franchised dealer. Ask with the VIN whether it was done.

Most recent: 24 January 2018

A12/0300/18Safety recallInjuries24 January 2018 · EU Safety Gate

The passenger airbag module may have been produced with an inadequate welded connection between the detonator and generator. In the event of an accident, the airbag may not deploy correctly, reducing the protection of the passenger.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: 24/01/2018

The authority's notice

Engine and transmission

2 engines · 1 transmissions

CUVC · 2.0 TDI

110 kW (150 HP) · diesel

DQ250 · 6-speed DSG, wet clutch

DSG · 6 speed

Clutchwet
Torque limit400 Nm
MakerVolkswagen

We built the code from the model and the gear count. The factory sheet does not state it. More than one engine code is possible. The fault list shows the faults of each.

Variant data

What is in this version

Factory data

Trim
Business Intense
Body
MPV
Fuel
diesel
Transmission
automatic
Engine size
1968 cc
Power
110 kW (150 HP)
Drive
FWD
Production
2015–2019

Factory service interval

The manufacturer specifies this for this version. Of the mileage and the time, the one that comes first is the one that counts.

  • Air filter

    • 60,000 km or 4 years

  • Cabin (pollen) filter

    • 30,000 km or 2 years

  • Engine oil and oil filter

    • LongLife30,000 km or 2 years(valid only with LongLife-approved oil)
    • 15,000 km or 1 year

  • Brake fluid change

    • first: 3 years, then 2 years(first change at 3 years, then every two years)

  • DSG oil change, WET clutch gearbox

    • 60,000 km or 4 years

  • Timing belt, 1.6 / 2.0 TDI (EA188/EA189/EA288)

    • 210,000 km(EA288, including the 1.6 TDI, with no time limit. 130,000 miles = 209,215 km. Parts maker repair specification, read by a human. The interval chart at https://www.rwcmotorsport.com/tech/tdi-maintenance.php gives the same figure independently.)

  • Coolant (antifreeze) change

    • first: 193,000 km or 10 years, then 97,000 km or 5 years(G13 / G12++: first change at 120,000 miles or 10 years, then every 60,000 miles or 5 years)

  • Fuel filter, diesel

    • 60,000 km or 2 years
All II versions

Information, not an expert opinion

We write the descriptions, and we put the source next to them. A person reviews them before they go out. They are still information, not a technical expert opinion.

  • A fault on the list does not mean the car you are looking at has it.
  • A fault missing from the list does not mean the model is fault-free. Write-ups are made model by model. Not all of them are done.
  • You decide whether to buy. This is no substitute for an inspection. That needs a workshop and a history check.
Details in the terms