A12/00444/21Safety recallFireno date · EU Safety Gate
Due to insufficient durability, the Exhaust Gas Recirculation (EGR) cooler may develop an internal coolant leak which could create smouldering deposits inside the EGR cooler and the intake manifold.
This may result in localised thermal damage in the intake system, which might lead to engine power reduction and to increased risk of fire.
Remedy: Type of economic operator taking notified measure(s): Importer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/00946/21Safety recallInjuriesno date · EU Safety Gate
The resistance characteristics of the fuel pump components against high fuel pressure may be inadequate.
As a result, cracks may be formed on the welded parts of the pump and a fuel leak may occur, posing a risk to the following traffic. The product does not comply with the requirements laid down in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Remedy: Type of economic operator taking notified measure(s): Importer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/01049/20Safety recallInjuriesno date · EU Safety Gate
Specific transistors in the boost converter of the Intelligent Power Module (IPM) can be damaged by the high thermal stress caused by repeated driving under certain high-load driving patterns (e.g. from a stop, applying nearly full throttle and then gradually further accelerating to full throttle).
This may cause the hybrid system to be shut down without entering a failsafe mode. As a result the vehicle may lose motive power while driving at higher speeds, increasing the risk of an accident.
Remedy: Type of economic operator taking notified measure(s): Importer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/02637/23Safety recallFireno date · EU Safety Gate
Insufficient pressing of parts in the high pressure fuel pump can cause movement of the cylinder in the fuel pump through which the piston moves. This can create wear between the cylinder and the pump body, resulting in increased stress on valves and/or movement valve seat inside the pump body. This increased stress can cause a crack in the weld of the affected valves, which could lead to a fuel leak, increasing the risk of fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Remedy: Type of economic operator taking notified measure(s): Importer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/0832/19Safety recallInjuriesno date · EU Safety Gate
The gas generator on the driver side frontal airbag may be defective. Metal fragments can be released when the airbag is activated, causing injury to the occupants.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
