A12/00069/19Safety recallInjuriesno date · EU Safety Gate
The four self-locking nuts used to attach the airbag might not have been correctly tightened. As a result, in the event of an accident in which the airbag was deployed, it could become detached from its base plate, failing to provide its restraining effect and increasing the risk of injuries.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/00531/22Safety recallInjuriesno date · EU Safety Gate
Improper torque of the screws on the brake caliper housing can cause the screw connections to become loose. As a result, the braking performance would be reduced and components of the brake caliper may be lost, increasing the risk of accidents. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/01337/20Safety recallFireno date · EU Safety Gate
The oil-supply pipe on the turbocharger may leak.
As a result, engine oil could leak onto the under-body paneling and from there onto the road, posing a risk to the following traffic.
Moreover, leaking engine oil might come into contact with hot components in the engine compartment, increasing the risk of fire.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/01523/21Safety recallFireno date · EU Safety Gate
The corrosion protection on the high voltage battery housing cannot be guaranteed to last for the whole lifetime of the vehicle. After the vehicle has been in use for a longer period of time, the high voltage battery housing could therefore corrode under certain specific environmental conditions. In this case, the sealing effect of the battery housing could then gradually be compromised, allowing moisture to penetrate the battery. This could lead to insulation failure, resulting in it being impossible to restart the vehicle once the engine has been switched off. Furthermore, this could increase the risk of fire. The product does not comply with the requirements laid down in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
INFO/00101/21Safety recallInjuriesno date · EU Safety Gate
The air-conditioning system's condensed-water drainage hose may be blocked, which may cause water to enter into the vehicle's interior.
Consequently, any electrical components installed there could be corroded and/or subjected to short circuits or leakage currents.
As a result, the Supplemental Restraint System (SRS) control unit could stop working, the vehicle may fail to start, the engine emergency run could be activated while the vehicle is in motion, and the functioning of other components (e.g. the fuel pump, automatic/manual emergency call) could be adversely affected.
This would increase the risk of injury and accident.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
