A12/00946/21Safety recallInjuriesno date · EU Safety Gate
The resistance characteristics of the fuel pump components against high fuel pressure may be inadequate.
As a result, cracks may be formed on the welded parts of the pump and a fuel leak may occur, posing a risk to the following traffic. The product does not comply with the requirements laid down in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Remedy: Type of economic operator taking notified measure(s): Importer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/02637/23Safety recallFireno date · EU Safety Gate
Insufficient pressing of parts in the high pressure fuel pump can cause movement of the cylinder in the fuel pump through which the piston moves. This can create wear between the cylinder and the pump body, resulting in increased stress on valves and/or movement valve seat inside the pump body. This increased stress can cause a crack in the weld of the affected valves, which could lead to a fuel leak, increasing the risk of fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Remedy: Type of economic operator taking notified measure(s): Importer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/1079/17Safety recallFireno date · EU Safety Gate
Certain portions of the wall of the fuel tank may be too thin. A crack could consequently develop in the wall of the fuel tank causing a leak which could lead to a fire.
Remedy: Type of economic operator taking notified measure(s): Importer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/1327/18Safety recallFireno date · EU Safety Gate
The engine wire harness has a cover attached where it is connected to the hybrid vehicle Power Control Unit. Due to assembly variation, a portion of the wire harness could contact the cover. If dust has accumulated on the wire harness or the cover, vibration during vehicle use may cause the insulation on the wires to wear over time and expose the core wire, causing an electrical short circuit to occur between the damaged wires and generate heat. If sufficient heat is generated, there is an increased risk of fire.
Remedy: Type of economic operator taking notified measure(s): Importer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/1679/17Safety recallInjuriesno date · EU Safety Gate
A fault with the skid control unit may result in an inability to release the parking brake or prevent the parking brake from being applied.
Remedy: Type of economic operator taking notified measure(s): Importer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
