18V850000STEERING:RACK AND PINION:RACKSTEERING:RACK AND PINION:RACK29 November 2018 · NHTSA (USA)
Mercedes-Benz USA, LLC (MBUSA) is recalling certain 2015-2016 Mercedes Benz C300, 2017-2019 C300 Cabrio, C300 Coupe, C63 Cabrio, 2015 C63S AMG, 2018-2019 C300, C350e, C63 AMG, C63S AMG Cabrio, 2018 C63 AMG Cabrio, C63 AMG Coupe, C63S AMG, C63S AMG Coupe, E300, E400 Cabrio, E400 Coupe, 2019 CLS450, E450 Cabrio, and E450 Coupe rear-wheel drive vehicles. A locknut in the steering rack may break under high load, possibly causing the steering to become stuck in one position.
Risk: A car that cannot be properly steered has an increased risk of a crash.
Remedy: MBUSA will notify owners, and dealers will replace the steering rack, free of charge. The recall began August 23, 2019. Owners may contact MBUSA customer service at 1-800-367-6372. MBUSA's number for this recall is 2019080012.
The authority's notice
A12/1352/17Safety recallFire1 September 2017 · EU Safety Gate
The starter current limiter may be overloaded and overheat. As a consequence, the surrounding components could ignite, leading to a fire.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: 01/09/2017
The authority's notice
15V845000STEERING:ELECTRIC POWER ASSIST SYSTEMSTEERING:ELECTRIC POWER ASSIST SYSTEM16 December 2015 · NHTSA (USA)
Mercedes-Benz USA, LLC (MBUSA) is recalling certain model year 2015 C300 and C400 4matic sedans manufactured January 27, 2014, to December 1, 2014. Due to an error in the electric power steering control unit software, the affected vehicles may have a loss of electric power steering assist.
Risk: If the vehicle experiences a loss of power steering assist, extra steering effort will be required, especially at lower speeds, increasing the risk of a vehicle crash.
Remedy: MBUSA will notify owners, and dealers will update the power steering software, free of charge. The recall began in January 15, 2016. Owners may contact MBUSA customer service at 1-800-367-6372.
The authority's notice
15V138000FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMPFUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP10 March 2015 · NHTSA (USA)
Mercedes-Benz USA, LLC. (MBUSA) is recalling certain model year 2015 C300 4matic and C400 4matic vehicles manufactured April 7, 2014, to July 25, 2014. In the affected vehicles, the fuel delivery module may be improperly secured to the fuel tank. Secondly, electrical wires that connect to the fuel delivery module might have been pinched between the flange of the fuel delivery module and the tank.
Risk: If the locking plate is not properly secured to the fuel delivery module it may become loose, and leak fuel, increasing the risk of a fire. If the electrical wires are pinched, the fuel pump may stop working, resulting in a stall, thereby increasing the risk of a crash.
Remedy: MBUSA will notify owners, and dealers will inspect the vehicles for improperly secured locking plates and pinched wires, correcting the vehicles as necessary, free of charge. The recal began on April 24, 2015. Owners may contact MBUSA customer service at 1-800-367-6372. MBUSA's number for this recall is 2015030004.
The authority's notice
15V087000EXTERIOR LIGHTING:HEADLIGHTSEXTERIOR LIGHTING:HEADLIGHTS11 February 2015 · NHTSA (USA)
Mercedes-Benz USA, LLC (MBUSA) is recalling certain model year 2015 C300 and C400 vehicles manufactured from June 18, 2014, through September 5, 2014, that fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 108, "Lamps, Reflective Devices, and Associated Equipment." The affected vehicles were assembled with horizontal adjustment mechanisms that allow the owner to change the horizontal adjustment used during the manufacturing process, instead of the proper sealing caps.
Risk: If the original horizontal adjustment is used to alter the low beam aim, the misaimed headlamp may not properly illuminated the road or cause increased glare to oncoming drivers, which increases the risk of a crash.
Remedy: Mercedes-Benz will notify owners, and dealers will replace the horizontal adjustment mechanisms on the headlamps with sealing caps on the affected vehicles. The recall began May 23, 2016. Owners may contact Mercedes at 1-800-367-6372.
The authority's notice
14V598000STEERINGSTEERING26 September 2014 · NHTSA (USA)
Mercedes-Benz USA, LLC (MBUSA) is recalling certain model year 2015 C300 4Matic and C400 4Matic vehicles manufactured March 28, 2014, to September 18, 2014. If the steering coupling interlock mechanism is not locked in place, the sliding shaft, which is part of the steering column, could become disengaged from the steering coupling socket due to vibrations, steering thrust, or load feedback from the road surface.
Risk: If the sliding shaft becomes disengaged from the steering coupling socket, the driver may experience noises, steering backlash, and in a worst case, loss of steering control, which may increase the risk of a crash.
Remedy: MBUSA has notified owners, and dealers will inspect the steering coupling interlock mechanism to verify that it is in the locked position, free of charge. The recall began on October 1, 2014. Owners may contact MBUSA customer service at 1-800-367-6372. MBUSA's number for this recall is 2014090008.
The authority's notice
A12/00323/21Safety recallFireno date · EU Safety Gate
The maximum permissible operating temperature of individual diodes on the alternator rectifier bridge could be exceeded and the diodes could subsequently fail.
Consequently, an improper flow of current from the on-board electrical system battery through the alternator to the vehicle earth could occur.
As a result, the windings in the alternator stator could be heated to such an extent that an outbreak of fire cannot be ruled out.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/00481/20Safety recallInjuriesno date · EU Safety Gate
The level sensors of the vibration damper software may not have been installed in the correct direction which can cause the headlamp levelling to be outside the tolerance limits.
If the vehicle is used with the maximum number of passengers, this will result in the oncoming traffic being affected by glare.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/0082/17Safety recallInjuriesno date · EU Safety Gate
The power-assisted steering control units may have been fitted with defectively welded contacts. As a result, a permanent electrical connection between the contacts cannot be guaranteed, which could lead to loss of support to the power-assisted steering and thus an increased risk of accidents.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/01448/22Safety recallEnvironment, Injuriesno date · EU Safety Gate
Faulty configurations of the control units (traction systems, signal recording triggering modules, engine control units and headlights) could cause one or more control units to malfunction, which could increase the risk of an accident. The exhaust emissions exceed the legal limits, posing a risk to the environment. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/0164/19Safety recallInjuriesno date · EU Safety Gate
There may be cracks in a securing nut in the steering gear of rear-wheel-drive vehicles. The nut could consequently break if the steering system is subject to a very high lateral force, which could result in rotating parts in the steering gear affecting the casing and thereby blocking the steering system.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/0296/19Safety recallInjuriesno date · EU Safety Gate
In vehicles with rear-wheel drive, a lock nut in the steering gear may be cracked. Consequently, when the steering is placed under high forces it could break, which would block the steering gear and increase the risk of accident.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice