21V032000SEAT BELTS:FRONT:RETRACTORSEAT BELTS:FRONT:RETRACTOR29 January 2021 · NHTSA (USA)
Mercedes-Benz USA, LLC (MBUSA) is recalling certain 2017-2021 C300, 2017-2020 AMG C43, and AMG C63 vehicles. The front seat belts might not fully retract to their stowed position. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 208, "Occupant Crash Protection."
Risk: If the seat belt does not fully retract, the occupant may find the operation of the seat belt inconvenient and not wear it, increasing the risk of injury in the event of a crash.
Remedy: MBUSA will notify owners, and dealers will check the retraction function of the front seat belts and adjust the damping foam within the B-pillars, as necessary, free of charge. The recall began February 26, 2021. Owners may contact MBUSA customer service at 1-800-367-6372. MBUSA's number for this recall is 2021020010.
The authority's notice
19V130000SEATSSEATS26 February 2019 · NHTSA (USA)
Mercedes-Benz USA, LLC (Mercedes) is recalling certain 2017-2018 Mercedes-Benz C300 Cabriolet, C300 Coupe, AMG C43 Coupe, C300 4MATIC Cabriolet, C300 4MATIC Coupe, AMG C43 Cabriolet, AMG C63 Cabriolet, AMG C63 Coupe, AMG C63 S Cabriolet and AMG C63 S Coupe vehicles and 2018 Mercedes-Benz E400 Coupe, E400 Cabriolet, E400 4MATIC Cabriolet and E400 4MATIC Coupe vehicles. The seatbacks of the front seats may not properly lock on the right side of the seat.
Risk: If the seatback does not properly lock, in the event of a crash, the seatbacks may fold forward, increasing the risk of injury.
Remedy: Mercedes will notify owners, and dealers will inspect the locking of the seatback on the affected vehicles and replace the seatback lock, as necessary, free of charge. An interim owner letter was mailed on April 12, 2019 to notify owners. Owners will receive a second notification when the remedy is available. Owners may contact Mercedes-Benz customer service at 1-800-367-6372. MBUSA's number for this recall is 2019040007.
The authority's notice
18V850000STEERING:RACK AND PINION:RACKSTEERING:RACK AND PINION:RACK29 November 2018 · NHTSA (USA)
Mercedes-Benz USA, LLC (MBUSA) is recalling certain 2015-2016 Mercedes Benz C300, 2017-2019 C300 Cabrio, C300 Coupe, C63 Cabrio, 2015 C63S AMG, 2018-2019 C300, C350e, C63 AMG, C63S AMG Cabrio, 2018 C63 AMG Cabrio, C63 AMG Coupe, C63S AMG, C63S AMG Coupe, E300, E400 Cabrio, E400 Coupe, 2019 CLS450, E450 Cabrio, and E450 Coupe rear-wheel drive vehicles. A locknut in the steering rack may break under high load, possibly causing the steering to become stuck in one position.
Risk: A car that cannot be properly steered has an increased risk of a crash.
Remedy: MBUSA will notify owners, and dealers will replace the steering rack, free of charge. The recall began August 23, 2019. Owners may contact MBUSA customer service at 1-800-367-6372. MBUSA's number for this recall is 2019080012.
The authority's notice
18V456000STRUCTURE:BODYSTRUCTURE:BODY10 July 2018 · NHTSA (USA)
Mercedes-Benz USA, LLC (MBUSA) is recalling certain 2017-2018 Mercedes C300 Cabriolet, C300 4Matic Cabriolet, C43 AMG Cabriolet, C63S AMG Cabriolet, and C63 AMG Cabriolet vehicles. Due to a bonding issue introduced in the production process, the rear beltline trim may separate from the vehicle.
Risk: If the beltline trim were to separate from the vehicle while driving, it could become a road hazard, increasing the risk of a crash.
Remedy: MBUSA will notify owners, and dealers will inspect the rear beltline trim and replace the trim if necessary, free of charge. The recall began on September 21, 2018. Owners may contact MBUSA customer service at 1-800-367-6372.
The authority's notice
18V207000SEATSSEATS29 March 2018 · NHTSA (USA)
Mercedes-Benz USA, LLC (MBUSA) is recalling certain 2017-2018 C43 AMG 4Matic Coupe, C300 Coupe, C300 4Matic Coupe, C300 4Matic Cabriolet, C300 Cabriolet, C43 AMG 4Matic Cabriolet and C63S AMG Cabriolet, 2017 C63 AMG Cabriolet, C63S AMG Coupe and C63 AMG Coupe, 2018 E400 Coupe and E400 4Matic Coupe vehicles. The seatbacks of the front seats may not properly lock on the right side of the seat.
Risk: If the seatback does not properly lock, in the event of a crash, the seatbacks may fold forward, increasing the risk of injury.
Remedy: MBUSA will notify owners, and dealers will inspect the locking of the seatbacks, replacing the seatbacks lock, as necessary, free of charge. The recall is expected to begin May 25, 2018. Owners may contact MBUSA customer service at 1-800-367-6372. MBUSA's number for this recall is 2018040007.
The authority's notice
A12/1352/17Safety recallFire1 September 2017 · EU Safety Gate
The starter current limiter may be overloaded and overheat. As a consequence, the surrounding components could ignite, leading to a fire.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: 01/09/2017
The authority's notice
17V243000STEERING:ELECTRIC POWER ASSIST SYSTEMSTEERING:ELECTRIC POWER ASSIST SYSTEM11 April 2017 · NHTSA (USA)
Mercedes-Benz USA, LLC. (MBUSA) is recalling certain 2016-2017 C300 vehicles. The electrical contacts for the power steering electric motor may not have been properly welded, possibly resulting in a loss of electrical contact.
Risk: A loss of electrical contact will cause the electric power steering assist to deactivate, increasing the risk of a crash.
Remedy: MBUSA will notify owners, and dealers will replace the electric power steering rack, free of charge. The recall began June 2017. Owners may contact MBUSA customer service at 1-800-367-6372.
The authority's notice
A12/00045/22Safety recallFireno date · EU Safety Gate
The vacuum-controlled coolant pump may not be tightly sealed between the coolant and vacuum circuits. This may result in the coolant leaking into the vacuum circuit leading to an electrochemical reaction, increasing the risk of fire. The product does not comply with the requirements laid down in the Regulation on the approval and market surveillance of Motor Vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/00323/21Safety recallFireno date · EU Safety Gate
The maximum permissible operating temperature of individual diodes on the alternator rectifier bridge could be exceeded and the diodes could subsequently fail.
Consequently, an improper flow of current from the on-board electrical system battery through the alternator to the vehicle earth could occur.
As a result, the windings in the alternator stator could be heated to such an extent that an outbreak of fire cannot be ruled out.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/00669/21Safety recallFire, Injuriesno date · EU Safety Gate
Faulty connection of the inerting system’s gas pipes could impair the intended distribution of argon shielding gas to the points where there could be contact between the leaking refrigerant R1234yf and hot engine components in the event of an accident.
This would reduce the cooling effect of the inerting gas, leading to increased risk of fire.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/0163/19Safety recallInjuriesno date · EU Safety Gate
In vehicles with automatic child-seat detection, the status shown in the centre console of the passenger airbags may not be correctly indicated. In this case, the vehicle users would not be correctly informed of the actual activation status of the passenger airbag and may not react appropriately to a potentially false passenger classification, thereby increasing the risk of injury for passengers in the event of an accident.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/0164/19Safety recallInjuriesno date · EU Safety Gate
There may be cracks in a securing nut in the steering gear of rear-wheel-drive vehicles. The nut could consequently break if the steering system is subject to a very high lateral force, which could result in rotating parts in the steering gear affecting the casing and thereby blocking the steering system.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/0296/19Safety recallInjuriesno date · EU Safety Gate
In vehicles with rear-wheel drive, a lock nut in the steering gear may be cracked. Consequently, when the steering is placed under high forces it could break, which would block the steering gear and increase the risk of accident.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/0626/17Safety recallInjuriesno date · EU Safety Gate
The propellant mixing ratio in certain seat-belt pre-tensioner igniters may be incorrect. As a result, in the event of an accident where the front seat-belt pre-tensioners are activated, the pre-tensioners would not provide the restraint performance required if the igniter did not ignite as intended. This could put the occupants at a greater risk of injury.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/0685/19Safety recallInjuriesno date · EU Safety Gate
The sleep mode functionality of the electronic parking brake within the electronic stability programme (ESP) software may be defective. As a result, the brake lights may be permanently activated or the ESP function could be deactivated, increasing the risk of an accident.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/0775/18Safety recallInjuriesno date · EU Safety Gate
The welding of the backrests of the driver's and front passenger's seats may be defective. In the event of an accident, the welding could break, increasing the risk of injury to the occupant of the seat in question.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/0957/18Safety recallInjuriesno date · EU Safety Gate
The seat-backs may not be fully secured on the right-hand side of the front seats. In the event of an accident, any unsecured objects on the rear seats of the vehicle may not be restrained, thereby increasing the risk of injury to passengers in the front seats.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/1372/18Safety recallInjuriesno date · EU Safety Gate
The decorative strips on the rear waist finisher have not been glued on correctly. As a consequence they can detach, fall into the road, increasing the risk of accident of the following traffic.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/1733/17Safety recallInjuriesno date · EU Safety Gate
The steering column is not sufficiently earthed. As a result, in the event of an electrostatic discharge, the driver's airbag may be triggered when not required. This could cause an accident.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
A12/1794/19Safety recallInjuriesno date · EU Safety Gate
The fixing screw connecting the base holder of the manual control device may not be correctly fitted. This can impair the control over the vehicle, increasing the risk of an accident.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
The authority's notice
