The balance shaft module drives the oil pump through a hexagonal shaft stub. That hex and its mating part gradually round off, until the shaft finally turns freely: the oil pump stops and the oil pressure is gone. The process gives no warning, and that is exactly what makes it dangerous. The failure typically happens at high revs, and the oil pressure light comes on only once the damage is already done. The factory hex is undersized, so it knocks against the wall of the bore, and the wear accelerates itself. The maker classed it as a "tolerance deviation" and, given the small number of cases against total production, did not recommend preventive repair; Audi alone ran a service action (13D7). The replacement is expensive: on the German market the module replacement is 1,300 to 1,700 euro, and an independent repair touching only the hex is around 650 euro. The reported cases cluster around the Passat B6, Sharan, Audi A4/A6, Superb and Alhambra, in model years between 2005 and 2009. This layout is not only on the pump-injector (PD) engines, it is on the common rail EA189 engines too: the same module, the same hex, the same wear. The failure is typically reported between 100,000 and 160,000 km. The first sign is a short flash of the oil pressure light, in a long bend or a few seconds after a cold start, and then quiet again. The versions without balance shafts (BKD, BMM, BMN, AZV) drive the oil pump differently and are not affected by this wear. If the light stays on or flashes, stop as soon as it is safe, switch the engine off, and do not restart it until the oil pressure has been measured.

The solenoids of the mechatronics unit wear out: slow or harsh shifting, then limp mode. A characteristic sign is the partial or complete loss of reverse. Wear of the clutch pack or the wrong spring force causes jerking and slipping. Because of the wet design it fails less often and at higher mileage than the dry DQ200, but when it does fail, it is expensive.

The internal springs of the flywheel tire, and the two discs knock against each other. The signs are a rattling or knocking from the bellhousing at idle and when releasing the clutch pedal, and vibration through the floor. If the clutch slips without a burnt smell, that also points to the flywheel. It is worth replacing in time: a disintegrated flywheel can destroy the bellhousing too. At a clutch replacement the two go together anyway.

The powered operation of the sliding door stops, and the door does not open or close by itself. The guide rail, the drive motor and the control unit can all cause it. Replacing them needs a lot of parts.

The vanes of the variable geometry turbo are glued together by soot and oil arriving through the EGR. First you get overboost or a lack of boost, then loss of power above 2,000 rpm, and finally limp mode. Caught in time it is enough to remove the turbo, clean it and fit a new actuator rod. Short urban trips and gentle, low rev driving speed up the deposits.

The G62 sensor tells the engine control unit how hot the coolant is. If it is faulty, the control unit thinks a warm engine is cold, and runs it rich: hard warm or cold starting, a rough idle, markedly increased fuel consumption, and a dash temperature gauge that jumps around or never reaches its usual reading. The part is cheap and can be replaced in half an hour: the trouble is that many people do not recognise it and replace an injector or a lambda sensor instead. If the fault persists, the rich mixture can destroy the catalytic converter too.

The dash shows "Error: Workshop! Only leave vehicle in position P" with an audible warning. The message appears in whatever language the car is set to, for example "Fehler: Werkstatt! Fahrzeug nur in Stellung P verlassen" in German.