With the 2008 EA888 VW switched from a belt to a chain, and the tensioner of the first two generations turned out weak: as the ratchet mechanism ages it does not hold its position when the engine stops and the oil pressure disappears. The oil drains overnight and the chain goes slack. The symptom looks harmless for a long time (a short, few second rattle on a cold start as the chain slaps the guide rail), and then one day it jumps, and the engine is badly damaged inside. From then on the repair is a cylinder head or an engine rebuild. Around 2012 the maker was already fitting an improved tensioner; on the old one only replacement helps, not monitoring the noise.

The light, magnesium cased MQ200 and the MQ250, sized for higher torque, are the most widespread manual gearboxes in the transverse engine VAG models. Both have the same two weak points, and both depend on use.

The combined housing of the water pump and the thermostat is plastic, and it is bolted directly to the hot engine block. The many heat and cool cycles warp it, it becomes brittle, and then it develops a hairline crack: the fault is almost always the housing, not the pump itself. The signs are slowly disappearing coolant with no visible puddle, the coolant level light, a sweet smell from the engine bay, and later a pink stain under the car. The repair means replacing the pump and the housing together, and the intake manifold has to come off for it: 4 to 6 hours of work. It shows up on model years 2015 to 2025.

With direct injection the fuel does not wash the intake valves: the petrol goes into the cylinder, not behind the valve. The oil mist and soot arriving through the EGR and the crankcase ventilation therefore build up on the valve stem and head, and from 80,000 to 100,000 km they restrict the flow. Symptoms are hesitation, loss of power, a rough cold start and misfire. It is not a part failure: it is a consequence of the design, and therefore it comes back. Cleaning (walnut or dry ice blasting) helps for a few tens of thousands of kilometres.

The crankcase breather carries the vapour that forms inside the engine back to the intake, and a rubber membrane regulates the pressure. Oil and heat harden this membrane until it tears, and from then on the intake draws air through the hole in it. The engine control unit does not measure that air, so the mixture goes wrong: the engine shakes at idle, stumbles when accelerating, and the fault memory gets P2279 for an intake system leak. In the other direction oil starts towards the intake, which leaves an oily film in the intercooler and on the intake pipe and speeds up the carbon build-up on the intake valves. The audible sign is a whistling or hissing noise from the engine bay, loudest at idle. The tear is reported between 60,000 and 90,000 km. On the first and second generation the breather is a separately replaceable valve (factory number 06H 103 495 AK) and costs between 80 and 400 euro; from the third generation it is built into the cam cover, so there the cover is replaced. The maker issued three versions up to 2016, and fitting the pressure variant that does not belong to the engine brings the same symptom back.

On some cars the control units do not go into sleep mode after the car is switched off, and the battery goes flat within days. The owner typically replaces the battery, and then the fault returns, because the battery is not the problem. The search starts with measuring the quiescent current, and the labour makes up the bigger part of the bill.

The tailgate responds with difficulty or not at all to the remote, sticks mechanically, or does not close properly. A tailgate that does not close also causes water ingress, and the boot electronics get wet.