A12/01389/21Safety recallInjuries10 September 2021 · EU Safety Gate
The bolt of the pressure-input shaft situated between the electromechanical brake servo and the brake pedal may come loose.
As a result, the mechanical connection between the brake pedal and the
brake servo would no longer be guaranteed, increasing the risk of an
accident.
In the event of an emergency, the vehicle can be immobilised by activating the electronic parking brake. The product does not meet the requirements set out in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: 10/09/2021
We could not check this: model year. The authority's notice
A12/0018/19Safety recallInjuriesno date · EU Safety Gate
The fitting for the headrest may have been incorrectly welded to the backrest. As a consequence, the supportive and protective effect of the headrest may be limited in the event of an accident.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
We could not check this: model year. The authority's notice
A12/00667/22Safety recallFire, Injuriesno date · EU Safety Gate
The fuse in the high-voltage (HV) system may have been produced with an insufficient amount of extinguishing sand. In the event of a short circuit in the high-voltage system, a voltage flashover could occur inside the vehicle and subsequently pose a risk of fire and injuries. The product does not comply with the Regulation on the approval and market surveillance of Motor Vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
We could not check this: model year. The authority's notice
A12/01247/22Safety recallInjuriesno date · EU Safety Gate
Deviations in the manufacturing process may result in either of the front seat belt reels not achieving full restraint, increasing the risk of injury in the event of an accident. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
We could not check this: model year. The authority's notice
A12/01957/24Safety recallInjuriesno date · EU Safety Gate
The propellant in the driver airbag may deteriorate over time. If the airbags deploy, it could result in fragments from the inflator injuring the vehicle's occupants. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
We could not check this: model year. The authority's notice
A12/0468/19Safety recallInjuriesno date · EU Safety Gate
The locking pin for securing the head restraints may be missing from the central rear seat. In the event of an accident, the central rear head restraint may consequently become detached from the guide rods and lose its supportive and protective effect.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
We could not check this: model year. The authority's notice
A12/0650/18Safety recallInjuriesno date · EU Safety Gate
The adhesive attaching the windscreen is not sufficiently secure. In the event of an accident, the protective effect of the passenger airbag could be compromised.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
We could not check this: model year. The authority's notice
A12/0834/19Safety recallInjuriesno date · EU Safety Gate
The handheld control unit for throttle and brake may develop a fracture in a welded joint in the relay mechanism. If this damage occurs this may lead to impaired functioning or even failure of the brake and gas control via the manual control device.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
We could not check this: model year. The authority's notice
A12/1475/19Safety recallInjuriesno date · EU Safety Gate
The headrest fitting on the rear seats may be defective. As a result, the support and protection provided by the headrest in the event of an accident could be impaired, increasing the risk of an injury.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
We could not check this: model year. The authority's notice
A12/1509/19Safety recallInjuriesno date · EU Safety Gate
The camshaft drive belt may not be resistant enough. Consequently, it may break or lead to the camshaft-phaser screws to loosen up and the engine oil to leak onto the roadway, increasing the risk of accident to following traffic.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
We could not check this: model year. The authority's notice
A12/1675/17Safety recallInjuriesno date · EU Safety Gate
The fatigue strength of the rear axle stub may be insufficient. This could result in failure of the rear axle stub with consequent loss of control of the vehicle.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
We could not check this: model year. The authority's notice
SR/00790/26Safety recallInjuriesno date · EU Safety Gate
The driver airbag inflator may cause uncontrolled inflation and release metal fragments when the airbag is activated, which can cause injury to the occupants. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Remedy: Type of economic operator taking notified measure(s): Manufacturer
Category of measure(s): Recall of the product from end users
Date of entry into force: Unknown
We could not check this: model year. The authority's notice
