vinkodex.

SEAT Alhambra 2.0 TDI 184hp FR Connect common faults.

2015–2019, MPV, diesel, 184 HP.

The fault list covers: CUWA engine, DQ250 transmission.

What you save stays on this device only. My saves

6 fault write-ups. 5 important. 1 recalls.

If you know the year, pick it. Faults for other years drop out of the list.

Before you buy

Known faults

5 important faults

critical1

The EGR cooler cools the recirculated exhaust gas before it enters the intake again, and coolant flows through it while it does so. The temperature difference between the two sides is large, so the wall can crack or the gasket can let through, and then the coolant reaches the exhaust or the intake side. This leaves no puddle under the car and the place of the leak is not visible from outside: the coolant evaporates and the level drops slowly, over weeks. The accompanying signs are whitish smoke, a rising coolant temperature, raised pressure in the cooling system and a sweetish smell. If it goes on for months the cylinder head can be damaged too, because the cooling gradually gets worse. On the EA189 engines the fault code P2425 usually comes with it. The problem is reported above 100,000 km, and replacing the cooler costs 600 to 1,500 euro.

above 100,000 km600–1,500 EUR

What to check

  • Look at the level in the expansion tank and ask how much has to be topped up
  • Look for traces outside: if the level drops but there is no puddle or streak, the leak is internal
  • After a cold start watch the exhaust, because lasting whitish smoke is not only condensation
2 more steps in the write-up

expensive4

The solenoids of the mechatronics unit wear out: slow or harsh shifting, then limp mode. A characteristic sign is the partial or complete loss of reverse. Wear of the clutch pack or the wrong spring force causes jerking and slipping. Because of the wet design it fails less often and at higher mileage than the dry DQ200, but when it does fail, it is expensive.

above 150,000 km

What to check

  • Pull away slowly from standstill and watch how smooth the 1 to 2 and 2 to 3 shifts are
  • Select reverse several times, cold and warm: is it delayed, does it engage at all
  • Under load (on a slope) watch whether the clutch slips
2 more steps in the write-up

The internal springs of the flywheel tire, and the two discs knock against each other. The signs are a rattling or knocking from the bellhousing at idle and when releasing the clutch pedal, and vibration through the floor. If the clutch slips without a burnt smell, that also points to the flywheel. It is worth replacing in time: a disintegrated flywheel can destroy the bellhousing too. At a clutch replacement the two go together anyway.

What to check

  • At idle, without touching the clutch pedal, listen for the rattle from the bellhousing, then press the pedal: if it stops, that is suspect
  • Watch for the characteristic clatter on starting and switching off
  • Put your foot on the floor at idle: a noticeable vibration indicates tired springs
2 more steps in the write-up

The combined housing of the water pump and the thermostat is plastic, and it is bolted directly to the hot engine block. The many heat and cool cycles warp it, it becomes brittle, and then it develops a hairline crack: the fault is almost always the housing, not the pump itself. The signs are slowly disappearing coolant with no visible puddle, the coolant level light, a sweet smell from the engine bay, and later a pink stain under the car. The repair means replacing the pump and the housing together, and the intake manifold has to come off for it: 4 to 6 hours of work. It shows up on model years 2015 to 2025.

What to check

  • Check the level in the expansion tank, and ask whether it needs topping up
  • With a cold engine, smell the engine bay: a sweet smell means a coolant leak
  • Shine a light under the intake manifold, on the right side of the engine: dried or pinkish deposits
2 more steps in the write-up

The powered tailgate often fails: it does not respond at all, opens only halfway, or stops while moving. The repair is replacing the drive motor or the control unit.

What to check

  • Open and close the powered tailgate five times, from the button and the key
  • Watch whether it stops halfway or reverses
  • Try it by hand too: a door that moves stiffly points to the gas strut
1 more steps in the write-up

cheap repair1

The dash shows "Error: Workshop! Only leave vehicle in position P" with an audible warning. The message appears in whatever language the car is set to, for example "Fehler: Werkstatt! Fahrzeug nur in Stellung P verlassen" in German.

Show the rest

The message points at the gearbox, but the fault is not there. A tiny switch sits in the module under the selector lever and signals that the lever is in park (P). Its contact wears and can also burn. That makes the signal unreliable, and the car warns you. The fault codes appear as 617752, P173400 or B116229.

At first it is intermittent. Sometimes the message comes up, sometimes not, so a short test drive easily misses it. Later it becomes permanent, and the gearbox can drop into limp mode.

This fault looks more expensive than it is. The maker released a separate retrofit switch kit for it (5Q0713128A for the black module, 3Q0713128 for the white one), which can be fitted in half an hour. The kit costs 70 to 100 pounds. At a franchised dealer, however, the whole selector lever module sometimes gets replaced, which costs 626 to 1,000 pounds there. So the difference between the two routes is roughly tenfold.

The affected group is post 2013 MQB platform Volkswagen, Audi, Seat and Skoda cars with a DSG gearbox. The switch is in these gearboxes, because that is what these cars have in common. The part itself is not part of the gearbox but of the module under the lever.

What to check

  • Watch the dash after starting: the message is intermittent and can be missed on a short loop
  • Move the lever from P to D and back several times, then get out and lock the car
  • Ask whether the selector lever switch has been replaced already, and ask for the invoice
2 more steps in the write-up

Checklist

SEAT Alhambra 2.0 TDI 184hp FR Connect

First what you would check on any car. Then the faults of this model.

Before you buy

Checklist

The printed sheet starts with what you would check on any car. What you tick stays on this device only.

On every car

Ask the owner

vinkodex.com · Before you buy it, see what can go wrong.

Official recall1 recallsShow

The manufacturer fixes these for free at a franchised dealer. Ask with the VIN whether it was done.

Most recent: 24 January 2018

A12/0300/18Safety recallInjuries24 January 2018 · EU Safety Gate

The passenger airbag module may have been produced with an inadequate welded connection between the detonator and generator. In the event of an accident, the airbag may not deploy correctly, reducing the protection of the passenger.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: 24/01/2018

The authority's notice

Engine and transmission

CUWA · 2.0 TDI

135 kW (184 HP) · diesel

DQ250 · 6-speed DSG, wet clutch

DSG · 6 speed

Clutchwet
Torque limit400 Nm
MakerVolkswagen

We built the code from the model and the gear count. The factory sheet does not state it.

Variant data

What is in this version

Factory data

Trim
FR Connect
Body
MPV
Fuel
diesel
Transmission
automatic
Engine size
1968 cc
Power
135 kW (184 HP)
Drive
FWD
Production
2015–2019

Factory service interval

The manufacturer specifies this for this version. Of the mileage and the time, the one that comes first is the one that counts.

  • Air filter

    • 60,000 km or 4 years
  • Cabin (pollen) filter

    • 30,000 km or 2 years
  • Engine oil and oil filter

    • LongLife30,000 km or 2 years(valid only with LongLife-approved oil)
    • 15,000 km or 1 year
  • Brake fluid change

    • first: 3 years, then 2 years(first change at 3 years, then every two years)
  • DSG oil change, WET clutch gearbox

    • 60,000 km or 4 years
  • Timing belt, 1.6 / 2.0 TDI (EA188/EA189/EA288)

    • 210,000 km(EA288, including the 1.6 TDI, with no time limit. 130,000 miles = 209,215 km. Parts maker repair specification, read by a human. The interval chart at https://www.rwcmotorsport.com/tech/tdi-maintenance.php gives the same figure independently.)
  • Coolant (antifreeze) change

    • first: 193,000 km or 10 years, then 97,000 km or 5 years(G13 / G12++: first change at 120,000 miles or 10 years, then every 60,000 miles or 5 years)
  • Fuel filter, diesel

    • 60,000 km or 2 years

Information, not an expert opinion

We write the descriptions, and we put the source next to them. A person reviews them before they go out. They are still information, not a technical expert opinion.

  • A fault on the list does not mean the car you are looking at has it.
  • A fault missing from the list does not mean the model is fault-free. Write-ups are made model by model. Not all of them are done.
  • You decide whether to buy. This is no substitute for an inspection. That needs a workshop and a history check.
Details in the terms