vinkodex.

Ford C-MAX 1.5 TDCI 95hp Trend common faults.

2015–2019, MPV, diesel, 95 HP.

The fault list covers: XXDA, XXDC, XXDD engine, IB6, MMT6 transmission.

What you save stays on this device only. My saves

4 fault write-ups. All are important. 1 recalls.

If you know the year, pick it. Faults for other years drop out of the list.

Before you buy

Known faults

4 important faults

MMT6 manual: worn shift mechanism, hard shifting when cold

expensive

The gearbox itself is reliable, but the shift mechanism wears noticeably between 100,000 and 150,000 km. Shifting becomes stiff, and it is most obvious when cold: the lever does not want to find its place, or the gear only goes in with force.

Show the rest

At high mileage the synchros on the first two gears wear out, and then the shift grates. The gearbox comes with a dual-mass flywheel, which is not the most durable part either.

between 100,000 and 150,000 km

What to check

  • Set off from cold: both first and second must engage without snagging
  • Stop and select reverse: it must not grate or need force
  • While rolling, change down into second: this is where worn synchros are audible
2 more steps in the write-up

Timing belt and tensioner: a non-original belt snaps sooner

expensive

The timing belt and its tensioner pulley are the weakest point of this engine. The factory specification is 150 000 kilometres or ten years, and whichever of the two comes first is what counts. A non-original belt, however, snaps at around 100 000 kilometres already, so the origin of the part is a question here too.

Show the rest

The quality of the change matters just as much. If the correct locking tools are not used during the belt change, the bar of the tensioner pulley is damaged, and the belt can jump.

If the belt snaps, the damage typically affects the valve rockers, and the valves themselves mostly survive. Even so the repair starts with opening up the cylinder head.

There are two production batches worth asking about separately. The examples built between December 2014 and May 2015 had a defective camshaft gear, which caused rapid cracking and valve damage. A campaign was launched for this in 2015 (16B42), in which the pulleys were replaced on several models.

The early sign is a squealing or droning noise from the direction of the timing belt cover.

between 100,000 and 150,000 km

What to check

  • Start it cold and listen to the noise from the direction of the timing belt cover
  • Ask for the invoice of the timing belt change: find out whether the tensioner pulley was replaced too
  • Ask whether a factory or an aftermarket belt went in: a non-original one snaps sooner
3 more steps in the write-up

EGR cooler: it cracks and the coolant goes into the intake

expensive

The EGR cooler can crack from the thermal load, and coolant gets into the intake through the crack. The fault is reported at around 120 000 kilometres.

Show the rest

The most telling sign is black foam in the expansion tank: the recirculated exhaust gas sooties up the coolant. With it comes the coolant going down while there is no leak from outside, white smoke from the exhaust, and the engine tending to run hot.

In severe cases the fluid getting into the intake causes a hydraulic lock, and engine damage follows from that. The fluid is not compressible, so once it is in the cylinder it is the connecting rod that has to give. The repair is replacement of the cooler, and it is not worth putting it off.

above 120,000 km

What to check

  • Open the expansion tank on a cold engine: black foam or dirty fluid indicates a cracked EGR cooler
  • Look at the coolant level and ask whether it has had to be topped up
  • Look for a puddle under the car: if the level drops but there is no puddle, the fluid goes inwards
3 more steps in the write-up

IB6 manual: little oil, leaks, and the synchro noise that follows

expensive

The gearbox is light and compact and reliable, but the small oil quantity makes it sensitive to leaks: not much has to escape before the level becomes critical.

Show the rest

Most complaints about synchro noise actually come from this, from the low oil level rather than from the synchro itself. Beyond that the input shaft bearing can wear out and reverse can fail. Every version comes with a dual-mass flywheel, which is not the most durable part.

What to check

  • Look at the gearbox housing from underneath: fresh oil means a leak, and here that is the main cause
  • Ask when the oil level was last checked and whether it has ever been topped up
  • While rolling, change down into second and third: grating means worn synchros
2 more steps in the write-up

Checklist

Ford C-MAX 1.5 TDCI 95hp Trend

First what you would check on any car. Then the faults of this model.

Before you buy

Checklist

The printed sheet starts with what you would check on any car. What you tick stays on this device only.

On every car

Ask the owner

Faults of this model

vinkodex.com · Before you buy it, see what can go wrong.

Official recall1 recallsShow

The manufacturer fixes these for free at a franchised dealer. Ask with the VIN whether it was done.

Most recent: 10 September 2018

18V592000EQUIPMENT:ELECTRICALEQUIPMENT:ELECTRICAL10 September 2018 · NHTSA (USA)

Ford Motor Company (Ford) is recalling certain 120V Convenience charge cords that were supplied with and sold for use with 2013-2015 Ford C-Max Energi and Fusion Energi vehicles and 2012-2015 Ford Focus Electric vehicles. Cords with part numbers FM58-10B706-AA, FM58-10B706-AB, FM58-10B706-AC, FM58-10B706-AD, FM58-10B706-AE and FM58-10B706-AF were manufactured without thermistors, and during vehicle charging, increased resistance in the house's outlet or wiring can cause the cord to overheat and melt.

Risk: An overheated cord can increase the risk of a fire.

Remedy: Ford will notify owners, and dealers will replace the current cord with a new 120V convenience cord with a thermistor, free of charge. The recall began January 18, 2019. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 18S24.

We could not check this: model year. The authority's notice

Engine and transmission

3 engines · 2 transmissions

XXDA · 1.5 TDCI FLH

70 kW (95 HP) · diesel

IB6 · 6-speed manual

manual · 6 speed

Torque limit285 Nm
MakerFord/Getrag

We built the code from the model and the gear count. The factory sheet does not state it. More than one engine code is possible. The fault list shows the faults of each. More than one transmission is possible. The gear count does not tell them apart. The code is on the side of the transmission.

Variant data

What is in this version

Factory data

Trim
Trend
Body
MPV
Fuel
diesel
Transmission
manual
Engine size
1499 cc
Power
70 kW (95 HP)
Drive
FWD
Production
2015–2019

Factory service interval

The manufacturer specifies this for this version. Of the mileage and the time, the one that comes first is the one that counts.

  • Air filter

    • 60,000 km or 4 years

  • Cabin (pollen) filter

    • 30,000 km or 2 years

  • Brake fluid change

    • first: 3 years, then 2 years(first change at 3 years, then every two years)

  • Fuel filter, diesel

    • 60,000 km or 2 years
All Mk2.5 versions

Information, not an expert opinion

We write the descriptions, and we put the source next to them. A person reviews them before they go out. They are still information, not a technical expert opinion.

  • A fault on the list does not mean the car you are looking at has it.
  • A fault missing from the list does not mean the model is fault-free. Write-ups are made model by model. Not all of them are done.
  • You decide whether to buy. This is no substitute for an inspection. That needs a workshop and a history check.
Details in the terms