vinkodex.

Mercedes-Benz CLA-Class CLA 250 e Shooting Brake Business Solution Luxury common faults.

2019–2023, estate, petrol, 160 HP.

The fault list covers: M282DE14AL engine, MB7DCT, MB8DCT transmission.

What you save stays on this device only. My saves

2 fault write-ups. Both are important. 7 recalls.

If you know the year, pick it. Faults for other years drop out of the list.

Before you buy

Known faults

2 important faults

critical1

On the M282 1.3 litre turbo petrol engine built in cooperation with Renault (A/B/CLA/GLA/GLB), a recall supervised by the German federal motor transport authority states that the turbo oil feed line could leak on cars built between 17 August 2019 and 6 July 2020.

Show the rest

The leaking engine oil can reach the underbody shield and from there the road (a skid risk for following traffic), and reaching hot engine bay parts it also presents a fire risk. The maker's action code is 0993022; around 8,270 cars worldwide, of which about 1,532 in Germany.

At the workshop the line is inspected and replaced if needed (about 90 minutes). On the GLB this is the most common petrol engine.

What to check

  • The build date first: the window is 17.08.2019 to 06.07.2020. Outside it this campaign does not apply
  • Ask the franchised dealer or the KBA database by VIN: is 0993022 OPEN or CLOSED
  • Look around the turbo for oil traces on the underbody shield and the heat shields
2 more steps in the write-up

expensive1

The 7 speed dual clutch of the transverse MFA platform (7G-DCT / 724.0: A/B/CLA/GLA/GLB) started its early years with jerking and firmware faults; today most of the complaints trace back to the mechatronics unit (valve body and solenoids) and the electric oil pump.

Show the rest

Driven with a faulty mechatronics unit, the wet dual clutch wears faster. The mechanical part (synchros, differential bearing) tends to appear at high mileage.

This is not the longitudinal 7G-Tronic (722.9): a different casing and a different fault pattern.

between 80,000 and 180,000 km

What to check

  • In town, crawling in traffic, watch for jerking between 1 to 2 and 2 to 3
  • Pulling away uphill or in a queue: a delayed clutch engagement is suspect
  • Ask for a fault code read on the DCT controller
2 more steps in the write-up

Checklist

Mercedes-Benz CLA-Class CLA 250 e Shooting Brake Business Solution Luxury

First what you would check on any car. Then the faults of this model.

Before you buy

Checklist

The printed sheet starts with what you would check on any car. What you tick stays on this device only.

On every car

Ask the owner

vinkodex.com · Before you buy it, see what can go wrong.

Official recall7 recallsShow

The manufacturer fixes these for free at a franchised dealer. Ask with the VIN whether it was done.

Most recent: 17 December 2021

21V989000STEERING:ELECTRIC POWER ASSIST SYSTEMSTEERING:ELECTRIC POWER ASSIST SYSTEM17 December 2021 · NHTSA (USA)

Mercedes-Benz USA, LLC (MBUSA) is recalling one 2020 CLA250 vehicle. The power supply connection to the electric power steering may have been contaminated with melted adhesive, which can cause the power steering assist to fail while driving.

Risk: A sudden loss of power steering assist can increase the risk of a crash.

Remedy: A dealer will inspect and repair the power supply connection, as necessary, free of charge. The owner notification letter was mailed January 21, 2021. Owners may contact MBUSA customer service at 1-800-367-6372. MBUSA's number for this recall is 2021120016.

The authority's notice

A12/00017/22Safety recallFireno date · EU Safety Gate

A trapped particle may damage the sealing between the fuel rail and fuel injector, which could cause fuel to leak into the engine compartment. Consequently, leaking fuel may come into contact with hot parts of the engine, increasing the risk of fire. The product does not comply with the requirements laid down in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

A12/00149/22Safety recallInjuriesno date · EU Safety Gate

The connection of the power supply to the electrical power steering may have been contaminated by heat-activated adhesive. Ageing of this adhesive could lead to a loss of clamping force and thus to a loose connection that may lead to interruption of the power supply. As a result, the electrical power steering could fail spontaneously, even while the vehicle is in motion, increasing the risk of an accident. The product does not comply with the requirements laid down in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

A12/00512/21Safety recallInjuriesno date · EU Safety Gate

The right-hand bracket on the right-hand rear seat designed to attach the child seat to the ISOFIX anchor point may be missing. As a result, there would be no restraining effect provided by the ISOFIX lower anchorage system and the child seat would not be sufficiently secured, increasing the risk of injury in the event of an accident.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

A12/00531/22Safety recallInjuriesno date · EU Safety Gate

Improper torque of the screws on the brake caliper housing can cause the screw connections to become loose. As a result, the braking performance would be reduced and components of the brake caliper may be lost, increasing the risk of accidents. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

A12/00730/21Safety recallInjuriesno date · EU Safety Gate

The polycarbonate roof panel located between the windscreen and the panoramic roof may not have been bonded correctly to the vehicle during a prior repair. In such cases, the adhesive bonding could gradually deteriorate and the panel could become detached from the vehicle, posing a risk to other road users. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

A12/01337/20Safety recallFireno date · EU Safety Gate

The oil-supply pipe on the turbocharger may leak. As a result, engine oil could leak onto the under-body paneling and from there onto the road, posing a risk to the following traffic. Moreover, leaking engine oil might come into contact with hot components in the engine compartment, increasing the risk of fire.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

Engine and transmission

1 engines · 2 transmissions

M282DE14AL

10–120 kW (14–163 HP) · petrol

MB7DCT · 7G-DCT (Mercedes 724.0, transverse dual-clutch)

DSG · 7 speed

Clutchwet
Torque limit350 Nm
MakerMercedes-Benz

We built the code from the model and the gear count. The factory sheet does not state it. More than one transmission is possible. 7 gears = MB7DCT, 8 gears = MB8DCT.

Variant data

What is in this version

Factory data

Trim
CLA 250 e Shooting Brake Business Solution Luxury
Body
estate
Fuel
petrol
Transmission
automatic
Engine size
1332 cc
Power
118 kW (160 HP)
Drive
FWD
Production
2019–2023

Factory service interval

The manufacturer specifies this for this version. Of the mileage and the time, the one that comes first is the one that counts.

  • Air filter

    • 60,000 km or 4 years
  • Cabin (pollen) filter

    • 30,000 km or 2 years
  • Brake fluid change

    • first: 3 years, then 2 years(first change at 3 years, then every two years)
  • Spark plugs, petrol

    • 60,000 km or 6 years

Information, not an expert opinion

We write the descriptions, and we put the source next to them. A person reviews them before they go out. They are still information, not a technical expert opinion.

  • A fault on the list does not mean the car you are looking at has it.
  • A fault missing from the list does not mean the model is fault-free. Write-ups are made model by model. Not all of them are done.
  • You decide whether to buy. This is no substitute for an inspection. That needs a workshop and a history check.
Details in the terms