vinkodex.

SEAT Leon 1.0 EcoTSI Style common faults.

2013–2017, estate, petrol, 115 HP.

The fault list covers: CHZD, DKRF engine, MQ200 transmission.

What you save stays on this device only. My saves

5 fault write-ups. 4 important. 1 recalls.

If you know the year, pick it. Faults for other years drop out of the list.

Before you buy

Known faults

4 important faults

critical1

The wiring harness running under the driver's seat kinks and breaks from the seat being adjusted. The sign is the airbag light staying on on the dash. With the airbag light on the system will not work in a crash, and it fails the roadworthiness test too. The part is cheap, the fault finding is the expensive bit, and many sellers mention it as "just a light".

What to check

  • After switching the ignition on, watch whether the airbag light goes out within a few seconds
  • Slide the seat fully forwards and backwards, and watch whether the light flashes up
  • Look at the wiring harness under the seat: broken insulation, chafe marks
1 more steps in the write-up

expensive3

The light, magnesium cased MQ200 and the MQ250, sized for higher torque, are the most widespread manual gearboxes in the transverse engine VAG models. Both have the same two weak points, and both depend on use.

Show the rest

The first is the differential bearing: as it wears you first get a droning, then a whine from the thrust bearings of the output shaft. Left alone, the planetary shaft can fail and in extreme cases punch through the gearbox casing: from then on it is not a repair but a replacement.

The second is the synchros: they can start crunching at around 50,000 km with aggressive driving. This type does not like dumping the clutch or slipping it, and on a used car that is exactly what you have to listen for.

above 50,000 km

What to check

  • On the test drive with the window down, listen to the gearbox both off and on the throttle: droning or whining is suspect
  • Shift up and down quickly, especially into 2nd and 3rd: crunching means synchro wear
  • Try engaging 1st and reverse when cold: resistance here means wear
2 more steps in the write-up

The door seal ages, and the water runs into the front footwell. It stays in the foam under the carpet, so for a long time only the misting windows and the musty smell show it. The comfort control unit and several connectors run in the footwell: if they corrode, the fault is electrical from then on.

What to check

  • Lift the front carpets and press the foam on both sides
  • Run your finger along the door seals: hard, cracked rubber is porous
  • Smell the cabin when cold
1 more steps in the write-up

In the EA211 the water pump and the thermostat are one plastic module, and the pump is driven not by the timing belt but by a separate toothed belt behind the exhaust camshaft. There are usually two problems with it: the plastic housing warps or cracks (slow coolant loss, a sweet smell, rising temperature), or the drive belt ages (a chirping noise, then an engine left with no cooling). The housing is particularly sensitive if oil reaches it: for example from a leaking crankcase ventilation. The module has to be replaced whole: dismantling it warps it in itself.

What to check

  • Check the level in the expansion tank, and ask whether it needs topping up
  • After a cold start smell the engine bay: a sweet smell means coolant
  • Look for dried, whitish pink deposits on the exhaust side of the cylinder head
2 more steps in the write-up

cheap repair1

The per cylinder ignition coil of these direct injection, turbocharged petrol engines fails. According to the Haynes service material this and similar simple electrical faults account for roughly eighty per cent of workshop visits.

Show the rest

In cold, damp weather, on startup, the engine runs unevenly, misfires under acceleration, and the engine warning light flashes or stays on. Do not keep driving with the light flashing: the unburnt fuel destroys the catalytic converter.

What to check

  • Start with a cold engine and watch the first half minute: a rough idle or shaking is suspect
  • On the test drive load the engine at low revs with a lot of throttle: the misfire shows then
  • A flashing engine warning light calls for stopping immediately
2 more steps in the write-up

Checklist

SEAT Leon 1.0 EcoTSI Style

First what you would check on any car. Then the faults of this model.

Before you buy

Checklist

The printed sheet starts with what you would check on any car. What you tick stays on this device only.

On every car

Ask the owner

vinkodex.com · Before you buy it, see what can go wrong.

Official recall1 recallsShow

The manufacturer fixes these for free at a franchised dealer. Ask with the VIN whether it was done.

Most recent: 21 November 2022

A12/00871/23Safety recallInjuries21 November 2022 · EU Safety Gate

The airbag may deteriorate over time and if deployed, excessive internal pressure may cause the inflator body to burst and metal fragments could pass through the cushion material causing injury to occupants. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: 21/11/2022

The authority's notice

Engine and transmission

2 engines · 1 transmissions

CHZD · 1.0 TFSI

85 kW (116 HP) · petrol

MQ200 · 5- or 6-speed manual

manual · 5–6 speed

Torque limit200 Nm
MakerVolkswagen

We built the code from the model and the gear count. The factory sheet does not state it. More than one engine code is possible. The fault list shows the faults of each.

Variant data

What is in this version

Factory data

Trim
EcoTSI Style
Body
estate
Fuel
petrol
Transmission
manual
Engine size
999 cc
Power
85 kW (116 HP)
Drive
FWD
Production
2013–2017

Factory service interval

The manufacturer specifies this for this version. Of the mileage and the time, the one that comes first is the one that counts.

  • Air filter

    • 60,000 km or 4 years
  • Cabin (pollen) filter

    • 30,000 km or 2 years
  • Engine oil and oil filter

    • LongLife30,000 km or 2 years(valid only with LongLife-approved oil)
    • 15,000 km or 1 year
  • Brake fluid change

    • first: 3 years, then 2 years(first change at 3 years, then every two years)
  • Coolant (antifreeze) change

    • first: 193,000 km or 10 years, then 97,000 km or 5 years(G13 / G12++: first change at 120,000 miles or 10 years, then every 60,000 miles or 5 years)
  • Spark plugs, petrol

    • 60,000 km or 6 years

Information, not an expert opinion

We write the descriptions, and we put the source next to them. A person reviews them before they go out. They are still information, not a technical expert opinion.

  • A fault on the list does not mean the car you are looking at has it.
  • A fault missing from the list does not mean the model is fault-free. Write-ups are made model by model. Not all of them are done.
  • You decide whether to buy. This is no substitute for an inspection. That needs a workshop and a history check.
Details in the terms