vinkodex.5 fault write-ups. 3 important. 3 recalls.
If you know the year, pick it. Faults for other years drop out of the list.
Before you buy
A thin wall of the mechatronics valve body can crack, which causes a loss of pressure. The typical signs: jerking and harsh shifting from 1st to 2nd at low speed, a flashing PRNDS display, then a gear engagement fault, intermittently at first.
What to check
In the EA211 the water pump and the thermostat are one plastic module, and the pump is driven not by the timing belt but by a separate toothed belt behind the exhaust camshaft. There are usually two problems with it: the plastic housing warps or cracks (slow coolant loss, a sweet smell, rising temperature), or the drive belt ages (a chirping noise, then an engine left with no cooling). The housing is particularly sensitive if oil reaches it: for example from a leaking crankcase ventilation. The module has to be replaced whole: dismantling it warps it in itself.
What to check
The electric assistance drops out: the steering suddenly goes heavy, typically while driving or when manoeuvring, and the power steering warning appears on the dash. Sometimes it is only intermittent, more often when cold. The fault is in the unit built into the steering column; the replacement is expensive relative to the value of a Polo. A refurbished unit can be fitted, but it needs coding.
What to check
The wheel cylinder and the shoe mechanism of the rear drum brake rust up, and the brake drags or seizes completely. The symptoms are a rear wheel heating up, pulling, weakening braking, and insufficient brake force on one side at the roadworthiness test. On a car that is used little and stands a lot it rusts sooner.
What to check
The dash shows "Error: Workshop! Only leave vehicle in position P" with an audible warning. The message appears in whatever language the car is set to, for example "Fehler: Werkstatt! Fahrzeug nur in Stellung P verlassen" in German.
The message points at the gearbox, but the fault is not there. A tiny switch sits in the module under the selector lever and signals that the lever is in park (P). Its contact wears and can also burn. That makes the signal unreliable, and the car warns you. The fault codes appear as 617752, P173400 or B116229.
At first it is intermittent. Sometimes the message comes up, sometimes not, so a short test drive easily misses it. Later it becomes permanent, and the gearbox can drop into limp mode.
This fault looks more expensive than it is. The maker released a separate retrofit switch kit for it (5Q0713128A for the black module, 3Q0713128 for the white one), which can be fitted in half an hour. The kit costs 70 to 100 pounds. At a franchised dealer, however, the whole selector lever module sometimes gets replaced, which costs 626 to 1,000 pounds there. So the difference between the two routes is roughly tenfold.
The affected group is post 2013 MQB platform Volkswagen, Audi, Seat and Skoda cars with a DSG gearbox. The switch is in these gearboxes, because that is what these cars have in common. The part itself is not part of the gearbox but of the module under the lever.
What to check
vinkodex.Checklist
First what you would check on any car. Then the faults of this model.
Before you buy
The printed sheet starts with what you would check on any car. What you tick stays on this device only.
The manufacturer fixes these for free at a franchised dealer. Ask with the VIN whether it was done.
Most recent: 31 August 2022
A12/01438/22Safety recallInjuries31 August 2022 · EU Safety GateThe propellant may deteriorate over time due to heat cycles and exposure to moisture. If the airbag is deployed, excessive internal pressure may cause the inflator body to burst and metal fragments could pass through the cushion material causing injury to occupants. The product does not comply with the requirements laid down in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: 31/08/2022
A12/01485/22Safety recallInjuriesno date · EU Safety GateThe airbag propellant may deteriorate over time. In the event of an accident this can lead to the release of fragments of the front airbag from the generator housing, increasing the risk of injury. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown
A12/01892/20Safety recallInjuriesno date · EU Safety GateThe vehicles affected may have been fitted with Takata gas generators which could allow the ingress of moisture and thus result in the degradation of the propellant. If the airbag deploys, this could cause the gas generator to burst, causing metal parts to enter the vehicle's interior, causing injuries to the occupants of the vehicle.
Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown
Variant data
The manufacturer specifies this for this version. Of the mileage and the time, the one that comes first is the one that counts.
Air filter
DQ200: lifetime fill by the maker, not in practice
Cabin (pollen) filter
Engine oil and oil filter
Brake fluid change
Coolant (antifreeze) change
Spark plugs, petrol
We write the descriptions, and we put the source next to them. A person reviews them before they go out. They are still information, not a technical expert opinion.