vinkodex.

Audi Q3 2.0 TDI 140hp Pro Line S common faults.

2011–2015, SUV, diesel, 140 HP.

The fault list covers: CFFB engine, MQ350 transmission.

What you save stays on this device only. My saves

5 fault write-ups. 4 important. 2 recalls.

If you know the year, pick it. Faults for other years drop out of the list.

Before you buy

Known faults

4 important faults

critical2

The EGR cooler cools the recirculated exhaust gas before it enters the intake again, and coolant flows through it while it does so. The temperature difference between the two sides is large, so the wall can crack or the gasket can let through, and then the coolant reaches the exhaust or the intake side. This leaves no puddle under the car and the place of the leak is not visible from outside: the coolant evaporates and the level drops slowly, over weeks. The accompanying signs are whitish smoke, a rising coolant temperature, raised pressure in the cooling system and a sweetish smell. If it goes on for months the cylinder head can be damaged too, because the cooling gradually gets worse. On the EA189 engines the fault code P2425 usually comes with it. The problem is reported above 100,000 km, and replacing the cooler costs 600 to 1,500 euro.

above 100,000 km600–1,500 EUR

What to check

  • Look at the level in the expansion tank and ask how much has to be topped up
  • Look for traces outside: if the level drops but there is no puddle or streak, the leak is internal
  • After a cold start watch the exhaust, because lasting whitish smoke is not only condensation
2 more steps in the write-up

The balance shaft module drives the oil pump through a hexagonal shaft stub. That hex and its mating part gradually round off, until the shaft finally turns freely: the oil pump stops and the oil pressure is gone. The process gives no warning, and that is exactly what makes it dangerous. The failure typically happens at high revs, and the oil pressure light comes on only once the damage is already done. The factory hex is undersized, so it knocks against the wall of the bore, and the wear accelerates itself. The maker classed it as a "tolerance deviation" and, given the small number of cases against total production, did not recommend preventive repair; Audi alone ran a service action (13D7). The replacement is expensive: on the German market the module replacement is 1,300 to 1,700 euro, and an independent repair touching only the hex is around 650 euro. The reported cases cluster around the Passat B6, Sharan, Audi A4/A6, Superb and Alhambra, in model years between 2005 and 2009. This layout is not only on the pump-injector (PD) engines, it is on the common rail EA189 engines too: the same module, the same hex, the same wear. The failure is typically reported between 100,000 and 160,000 km. The first sign is a short flash of the oil pressure light, in a long bend or a few seconds after a cold start, and then quiet again. The versions without balance shafts (BKD, BMM, BMN, AZV) drive the oil pump differently and are not affected by this wear. If the light stays on or flashes, stop as soon as it is safe, switch the engine off, and do not restart it until the oil pressure has been measured.

between 100,000 and 160,000 km

What to check

  • Ask whether the balance shaft module or the oil pump drive has been replaced, and if so, with a factory or a strengthened hex
  • Read through the service book: has an oil pressure warning ever flashed, even once
  • Unscrew the oil filler cap and look for metallic glitter in the lubricant
3 more steps in the write-up

expensive2

The EGR valve and its cooler block up with soot and oily deposits; the particulate filter cannot regenerate on short urban trips. The signs are reduced power, a warning light, and frequent regeneration. The software update after the diesel emissions affair made the EGR operate more often, which accelerated the phenomenon: the maker gave goodwill repairs in several cases.

between 140,000 and 160,000 km

What to check

  • Ask what kind of journeys the car did: a daily short urban run is the worst for the filter
  • With a code reader look at the stored faults (P0401/P0402, and P2002 for the filter)
  • Ask whether it received the post emissions affair software update, and when
1 more steps in the write-up

The internal springs of the flywheel tire, and the two discs knock against each other. The signs are a rattling or knocking from the bellhousing at idle and when releasing the clutch pedal, and vibration through the floor. If the clutch slips without a burnt smell, that also points to the flywheel. It is worth replacing in time: a disintegrated flywheel can destroy the bellhousing too. At a clutch replacement the two go together anyway.

What to check

  • At idle, without touching the clutch pedal, listen for the rattle from the bellhousing, then press the pedal: if it stops, that is suspect
  • Watch for the characteristic clatter on starting and switching off
  • Put your foot on the floor at idle: a noticeable vibration indicates tired springs
2 more steps in the write-up

comfort1

The most common complaint on the Q3 is the infotainment system: the touchscreen does not respond, dash warnings flicker, the system freezes, or a sensor is faulty. One survey found a fault of this kind on 44 per cent of Q3 cars, and half of the repairs spent more than a week in the workshop. A software update fixes many cases and the update is free, so before you buy, ask whether the latest version is installed.

What to check

  • Leave the system running for the whole test drive and watch for freezing
  • Try the parking sensors and the driver assistance systems
  • Restart the car several times: a fault after a cold start is characteristic
2 more steps in the write-up

Checklist

Audi Q3 2.0 TDI 140hp Pro Line S

First what you would check on any car. Then the faults of this model.

Before you buy

Checklist

The printed sheet starts with what you would check on any car. What you tick stays on this device only.

On every car

Ask the owner

vinkodex.com · Before you buy it, see what can go wrong.

Official recall2 recallsShow

The manufacturer fixes these for free at a franchised dealer. Ask with the VIN whether it was done.

A12/1252/19Safety recallInjuriesno date · EU Safety Gate

The function control device of the Body Control Module (BCM) may be incorrectly configured. This may cause a malfunction of the front light-emitting diode (LED) turn signal lights (blinkers) without the required warning indicator (acoustic/optical), increasing the risk of an accident.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

A12/1639/17Safety recallInjuriesno date · EU Safety Gate

When emergency braking is actuated using the EPB (electro-mechanical parking brake), the braking lights are not activated. Following traffic is not informed of the emergency braking operation and the resulting deceleration of the vehicle which could lead to an accident.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

Engine and transmission

CFFB · 2.0 TDI

103 kW (140 HP) · diesel

MQ350 · 6-speed manual

manual · 6 speed

Torque limit400 Nm
MakerVolkswagen

We built the code from the model and the gear count. The factory sheet does not state it.

Variant data

What is in this version

Factory data

Trim
Pro Line S
Body
SUV
Fuel
diesel
Transmission
manual
Engine size
1968 cc
Power
103 kW (140 HP)
Drive
FWD
Production
2011–2015

Factory service interval

The manufacturer specifies this for this version. Of the mileage and the time, the one that comes first is the one that counts.

  • Air filter

    • 60,000 km or 4 years
  • Cabin (pollen) filter

    • 30,000 km or 2 years
  • Engine oil and oil filter

    • LongLife30,000 km or 2 years(valid only with LongLife-approved oil)
    • 15,000 km or 1 year
  • Brake fluid change

    • first: 3 years, then 2 years(first change at 3 years, then every two years)
  • Timing belt, 1.6 / 2.0 TDI (EA188/EA189/EA288)

    • 210,000 km(EA288, including the 1.6 TDI, with no time limit. 130,000 miles = 209,215 km. Parts maker repair specification, read by a human. The interval chart at https://www.rwcmotorsport.com/tech/tdi-maintenance.php gives the same figure independently.)
  • Coolant (antifreeze) change

    • first: 193,000 km or 10 years, then 97,000 km or 5 years(G13 / G12++: first change at 120,000 miles or 10 years, then every 60,000 miles or 5 years)
  • Fuel filter, diesel

    • 60,000 km or 2 years

Information, not an expert opinion

We write the descriptions, and we put the source next to them. A person reviews them before they go out. They are still information, not a technical expert opinion.

  • A fault on the list does not mean the car you are looking at has it.
  • A fault missing from the list does not mean the model is fault-free. Write-ups are made model by model. Not all of them are done.
  • You decide whether to buy. This is no substitute for an inspection. That needs a workshop and a history check.
Details in the terms