vinkodex.

Audi SQ5 3.0 TDI quattro Plus Pro Line common faults.

2012–2017, SUV, diesel, 340 HP.

The fault list covers: DEHA engine, AL551 transmission.

What you save stays on this device only. My saves

5 fault write-ups. 4 important. 6 recalls.

If you know the year, pick it. Faults for other years drop out of the list.

Before you buy

Known faults

4 important faults

expensive4

B8 platform: the actuator motor of the electric parking brake

expensive

A small electric motor built into the rear brake calipers applies the parking brake. This is a known weak point of the B8 platform (A4 B8, A5 8T, Q5 8R, allroad B8): moisture and road salt get into the motor housing, the electronics corrode, and the gears seize. The symptom is a parking brake that will not apply or will not release, with a fault message.

Show the rest

Two things are worth knowing about it. First, the system is sensitive to voltage: a weak battery dropping below 12.2 V can trigger an intermittent parking brake fault on its own, especially in the cold. In that case it is not the brake that needs replacing. Second, servicing the rear brake requires putting the caliper into service mode with a diagnostic tool; forcing the piston back by hand destroys the actuator itself.

above 50,000 km

What to check

  • Apply and release the parking brake several times in a row: it must work evenly and without a fault in both directions
  • Stop the car on a slope on the parking brake alone: it has to hold
  • After switching the ignition on, check for a parking brake or hill hold fault message
2 more steps in the write-up

Four link aluminium front suspension: bushes and ball joints

expensive

The front suspension of the longitudinal engine Audis (and the Seat Exeo derived from them) works with four control arms per side: two above, two below. That gives excellent steering when new, but it also means four ball joints and eight bushes per side: sixteen wear points at the front in total.

Show the rest

The first complaints appear at around 100,000 to 120,000 km: knocking over bumps, squeaking, vague steering, vibration through the wheel at higher speed, and uneven tyre wear from the disturbed suspension geometry.

Replacing a single arm is not expensive, but it rarely stops at one, and the work also needs a wheel alignment afterwards. Workshops therefore offer a full arm kit, which is a serious item, and an excellent bargaining point, because you can hear it on the test drive and see it on the tyres.

between 100,000 and 120,000 km

What to check

  • On an uneven road at 30 to 50 km/h listen for dull knocking and squeaking from the front
  • Standing still with the engine running, turn the wheel back and forth: there should be no clicking or rattling
  • Look at the inner and outer edges of all four tyres: uneven wear is the surest sign
2 more steps in the write-up

Dual mass flywheel: diesel

expensive

The internal springs of the flywheel tire, and the two discs knock against each other. The signs are a rattling or knocking from the bellhousing at idle and when releasing the clutch pedal, and vibration through the floor. If the clutch slips without a burnt smell, that also points to the flywheel. It is worth replacing in time: a disintegrated flywheel can destroy the bellhousing too. At a clutch replacement the two go together anyway.

What to check

  • At idle, without touching the clutch pedal, listen for the rattle from the bellhousing, then press the pedal: if it stops, that is suspect
  • Watch for the characteristic clatter on starting and switching off
  • Put your foot on the floor at idle: a noticeable vibration indicates tired springs
2 more steps in the write-up

TDI: the vanes of the variable geometry (VNT) turbo stick

expensive

The vanes of the variable geometry turbo are glued together by soot and oil arriving through the EGR. First you get overboost or a lack of boost, then loss of power above 2,000 rpm, and finally limp mode. Caught in time it is enough to remove the turbo, clean it and fit a new actuator rod. Short urban trips and gentle, low rev driving speed up the deposits.

What to check

  • On the motorway, load it above 2,000 rpm: does it pull evenly, or does the power break up
  • Watch whether the warning light flashes up under acceleration (overboost protection)
  • Ask what kind of journeys it did: a daily short urban run is the worst
1 more steps in the write-up

comfort1

Coolant temperature sensor (G62) failure

comfort

The G62 sensor tells the engine control unit how hot the coolant is. If it is faulty, the control unit thinks a warm engine is cold, and runs it rich: hard warm or cold starting, a rough idle, markedly increased fuel consumption, and a dash temperature gauge that jumps around or never reaches its usual reading. The part is cheap and can be replaced in half an hour: the trouble is that many people do not recognise it and replace an injector or a lambda sensor instead. If the fault persists, the rich mixture can destroy the catalytic converter too.

What to check

  • Warm it up and watch the dash temperature gauge: the needle should sit steadily at the middle reading, not jump around
  • Watch a cold start, then a warm start after twenty minutes standing
  • With a code reader look for the 17664 / P1256 code in the engine control unit
2 more steps in the write-up

Checklist

Audi SQ5 3.0 TDI quattro Plus Pro Line

First what you would check on any car. Then the faults of this model.

Before you buy

Checklist

The printed sheet starts with what you would check on any car. What you tick stays on this device only.

On every car

Ask the owner

Faults of this model

vinkodex.com · Before you buy it, see what can go wrong.

Official recall6 recallsShow

The manufacturer fixes these for free at a franchised dealer. Ask with the VIN whether it was done.

Most recent: 11 April 2018

18V229000ENGINE AND ENGINE COOLING:COOLING SYSTEMENGINE AND ENGINE COOLING:COOLING SYSTEM11 April 2018 · NHTSA (USA)

Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2013-2017 Audi A5 Cabriolet, A5 Sedan and Audi Q5 vehicles, 2012-2015 Audi A6 vehicles and 2013-2016 Audi A4 Sedan and A4 allroad vehicles. These vehicles, equipped with 2.0l Turbo FSI engines, have an electric coolant pump that can either become blocked with debris from the cooling system causing it to overheat or can short-circuit from moisture within the pump.

Risk: A blocked pump or a short-circuited pump can increase the risk of a fire.

Remedy: Audi will notify owners, and dealers will replace the pumps, free of charge. The recall began September 14, 2018. Owners may contact Audi customer service at 1-800-253-2834. Audi's number's for this recall is 19N3/19N4. Note: This recall is in additional to the coolant pump software update applied as a remedy under recall 17V002.

The authority's notice

17V297000POWER TRAIN:AUTOMATIC TRANSMISSION:GEAR POSITION INDICATION (PRNDL)POWER TRAIN:AUTOMATIC TRANSMISSION:GEAR POSITION INDICATION (PRNDL)3 May 2017 · NHTSA (USA)

Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2017 Audi Q5 vehicles. Due to a manufacturing defect within the gearbox, despite selecting the Park position, the vehicle may still unexpectedly roll.

Risk: Despite selecting 'Park', if the parking brake is not applied, the vehicle may rollaway, increasing the risk of a crash.

Remedy: Audi will notify owners, and dealers will replace the geabox in the affected vehicles, free of charge. The recall began May 15, 2017. Owners may contact Audi customer service at 1-800-253-2834. Volkswagen's number for this recall is 37K6.

The authority's notice

17V001000VISIBILITY:SUN/MOON ROOF ASSEMBLYVISIBILITY:SUN/MOON ROOF ASSEMBLY3 January 2017 · NHTSA (USA)

Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2011-2017 Audi Q5 vehicles. The sunroof drainage system may allow water to soak into the foam surrounding the side head air bag inflator canister resulting in the corrosion of the canister. If this happens, the corrosion can weaken the canister and the inflator could fracture without air bag deployment, propelling fragments into the passenger compartment, striking and causing serious injury to vehicle occupants.

Risk: An inflator rupture may result in metal fragments striking the driver or other occupants resulting in serious injury or death.

Remedy: Audi will notify owners, and dealers will inspect the inflator and either coat it or replace it, as necessary, after removing the surrounding foam, free of charge. The recall is expected to began March 2017. Owners may contact Audi customer service at 1-800-253-2834. Volkswagen's number for this recall is 69P1.

The authority's notice

17V002000ENGINE AND ENGINE COOLING:COOLING SYSTEMENGINE AND ENGINE COOLING:COOLING SYSTEM3 January 2017 · NHTSA (USA)

Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2013-2017 Audi A5, A5 Cabriolet and Q5 vehicles, 2013-2016 Audi Allroad and Audi A4 vehicles and 2012-2015 Audi A6 vehicles. These vehicles, equipped with 2.0l Turbo FSI engines, have an electric coolant pump that can be blocked with debris from the cooling system, resulting in the pump overheating.

Risk: If the coolant pump overheats, it can increase the risk of a fire.

Remedy: Audi will notify owners, and dealers will update the software so that the power supply to the coolant pump is deactivated if the pump becomes blocked with debris, free of charge. The recall is expected to begin February 20, 2017. Owners may contact Audi customer service at 1-800-253-2834. Volkswagen's number for this recall is 19M1.

The authority's notice

A12/00689/20Safety recallFireno date · EU Safety Gate

Moisture can penetrate into the belt starter generator. This can result in a short circuit, leading to local overheating and increased risk of fire. Due to the permanent power supply of the starter generator, this can occur when the vehicle has already been parked for a while.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

A12/01401/20Safety recallFireno date · EU Safety Gate

Moisture can ingress into the belt starter generator, generating short-circuits. This can lead to local overheating of the component, increasing risk of fire.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

Engine and transmission

DEHA

250 kW (340 HP) · diesel

AL551 · 8-speed automatic (longitudinal)

automatic · 8 speed

Torque limit700 Nm
MakerZF

We built the code from the model and the gear count. The factory sheet does not state it.

Variant data

What is in this version

Factory data

Trim
quattro Plus Pro Line
Body
SUV
Fuel
diesel
Transmission
automatic
Engine size
2967 cc
Power
250 kW (340 HP)
Drive
AWD
Production
2012–2017

Factory service interval

The manufacturer specifies this for this version. Of the mileage and the time, the one that comes first is the one that counts.

  • Air filter

    • 60,000 km or 4 years

  • Cabin (pollen) filter

    • 30,000 km or 2 years

  • Engine oil and oil filter

    • LongLife30,000 km or 2 years(valid only with LongLife-approved oil)
    • 15,000 km or 1 year

  • Brake fluid change

    • first: 3 years, then 2 years(first change at 3 years, then every two years)

  • Coolant (antifreeze) change

    • first: 193,000 km or 10 years, then 97,000 km or 5 years(G13 / G12++: first change at 120,000 miles or 10 years, then every 60,000 miles or 5 years)

  • Fuel filter, diesel

    • 60,000 km or 2 years
All 8R versions

Information, not an expert opinion

We write the descriptions, and we put the source next to them. A person reviews them before they go out. They are still information, not a technical expert opinion.

  • A fault on the list does not mean the car you are looking at has it.
  • A fault missing from the list does not mean the model is fault-free. Write-ups are made model by model. Not all of them are done.
  • You decide whether to buy. This is no substitute for an inspection. That needs a workshop and a history check.
Details in the terms