vinkodex.

Audi Q7 3.0 TFSI quattro common faults.

2015–2019, SUV, petrol, 333 HP.

The fault list covers: CREC engine, AL952 transmission.

What you save stays on this device only. My saves

3 fault write-ups. 2 important. 15 recalls.

If you know the year, pick it. Faults for other years drop out of the list.

Before you buy

Known faults

2 important faults

expensive2

The four groups of parts in the air suspension (compressor, valve block, ride height sensors, air springs) work together, and any weak link causes a fault message, an uneven ride height or a car that settles. The characteristic symptom: the car sits down on one corner overnight, levels itself for minutes in the morning, and the compressor runs long and loud. According to the reports the compressor lasts 80,000 to 100,000 km; and a leaking air spring takes the compressor with it, because it keeps trying to make up the loss.

What to check

  • Look at the car cold, after standing a long time: has it settled on any corner
  • After startup time how long it takes to level, and listen to the compressor
  • Cycle through the ride height settings in the onboard menu and check that all of them work
3 more steps in the write-up

With direct injection the fuel does not wash the intake valves: the petrol goes into the cylinder, not behind the valve. The oil mist and soot arriving through the EGR and the crankcase ventilation therefore build up on the valve stem and head, and from 80,000 to 100,000 km they restrict the flow. Symptoms are hesitation, loss of power, a rough cold start and misfire. It is not a part failure: it is a consequence of the design, and therefore it comes back. Cleaning (walnut or dry ice blasting) helps for a few tens of thousands of kilometres.

What to check

  • After a cold start watch the idle: rough running and shaking point to coked valves
  • Under load at low revs watch for hesitation
  • With a code reader look for per cylinder misfire (P0300 to P0304)
1 more steps in the write-up

comfort1

The G62 sensor tells the engine control unit how hot the coolant is. If it is faulty, the control unit thinks a warm engine is cold, and runs it rich: hard warm or cold starting, a rough idle, markedly increased fuel consumption, and a dash temperature gauge that jumps around or never reaches its usual reading. The part is cheap and can be replaced in half an hour: the trouble is that many people do not recognise it and replace an injector or a lambda sensor instead. If the fault persists, the rich mixture can destroy the catalytic converter too.

What to check

  • Warm it up and watch the dash temperature gauge: the needle should sit steadily at the middle reading, not jump around
  • Watch a cold start, then a warm start after twenty minutes standing
  • With a code reader look for the 17664 / P1256 code in the engine control unit
2 more steps in the write-up

Checklist

Audi Q7 3.0 TFSI quattro

First what you would check on any car. Then the faults of this model.

Before you buy

Checklist

The printed sheet starts with what you would check on any car. What you tick stays on this device only.

On every car

Ask the owner

vinkodex.com · Before you buy it, see what can go wrong.

Official recall15 recallsShow

The manufacturer fixes these for free at a franchised dealer. Ask with the VIN whether it was done.

Most recent: 23 April 2021

A12/01220/21Safety recallEnvironment23 April 2021 · EU Safety Gate

The vehicles are equipped with control software regarded as unauthorised by the competent authorities. The product does not comply with the requirements laid down in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Importer Category of measure(s): Recall of the product from end users Date of entry into force: 23/04/2021

We could not check this: model year. The authority's notice

A12/00070/19Safety recallFireno date · EU Safety Gate

Due to the incompatibility of the control software with the heating film used for the front camera on the windscreen, significant overheating may occur when the heating element is controlled after the ignition is switched on or at low temperatures. This may lead to a smouldering and increase the risk of the vehicle catching fire.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

A12/00409/24Safety recallInjuriesno date · EU Safety Gate

The side airbag is insufficiently secured to the front left-hand side of the seat frame. As a result, it may not be able to deploy correctly in the event of an accident, increasing the risk of injury to the occupants. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

A12/00465/20Safety recallInjuriesno date · EU Safety Gate

Possible defect in the locking mechanism on the front head restraints may cause them to unintentionally shift in height when placed under pressure. This could impair the protective effect of head restraints in the event of an accident, increasing the risk of injuries.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

A12/00504/22Safety recallInjuriesno date · EU Safety Gate

Alteration of the rear axle’s toe and/or camber values lead to increased and uneven wear on the rear tyres, and if worn down to its carcass may suffer a sudden loss of pressure. This can lead to loss of traction and may affect vehicle handling, increasing the risk of an accident. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

A12/00547/20Safety recallInjuriesno date · EU Safety Gate

The screw connection between the steering shaft and the steering box may not have been tightened sufficiently and may loosen over time. This will impair the vehicle’s steerability, increasing the risk of an accident.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

A12/00624/20Safety recallInjuriesno date · EU Safety Gate

The joint on the discharge nozzle of the gas generator for the curtain airbag might have been inappropriately welded. In the event of an accident triggering the curtain air bag, the joint could fail impairing the proper inflation of the airbag, increasing the risk of injuries.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

A12/00997/20Safety recallInjuriesno date · EU Safety Gate

An oil line in the automatic gearbox may have a manufacturing defect. Consequently, oil may leak out onto the road, posing a risk to the following traffic.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

A12/03031/23Safety recallInjuriesno date · EU Safety Gate

A defective welding seam on the front seat back frame can break in the event of an accident. As a result, the person sitting in the seat may hit their head on the B-pillar, increasing the risk of injury. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

A12/0333/17Safety recallInjuriesno date · EU Safety Gate

Differences in the mixture ratio for the initiating devices for the airbags or seat-belt pre-tensioners could lead to the airbags or seat-belt pre-tensioners not activating in the event of an accident.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

A12/0382/19Safety recallFireno date · EU Safety Gate

In certain vehicles, fuel can leak onto the engine fuel rail. Fuel leakage close to a source of ignition may increase the risk of the vehicle catching fire.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

A12/0618/19Safety recallInjuriesno date · EU Safety Gate

A component of the wheel suspension may not be strong enough and could break over time. As a consequence, the tyre may press against the wheel arch which poses a risk of accidents.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

INFO/00089/21Safety recallInjuriesno date · EU Safety Gate

Faulty crash sensors for the airbag restraint systems may have been installed in both the front doors. This could impair the protective effect of the side airbags, head airbags and/or belt tensioners, increasing the risk of injury in the event of an accident.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

INFO/00138/21Safety recallInjuriesno date · EU Safety Gate

The nuts on the eccentric bolt of the rear-axle spring-link control arm may break due to stress corrosion. As a result, the rear axle could move in the wrong direction, in an uncontrollable manner at high speeds.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

SR/03859/25Safety recallFireno date · EU Safety Gate

The cell modules of the high-voltage battery could overheat during charging which can lead to a fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

Engine and transmission

CREC · 3.0 TFSI (S4)

245 kW (333 HP) · petrol

AL952 · 8-speed automatic (high-torque, longitudinal)

automatic · 8 speed

Torque limit950 Nm
MakerZF

We built the code from the model and the gear count. The factory sheet does not state it.

Variant data

What is in this version

Factory data

Trim
quattro
Body
SUV
Fuel
petrol
Transmission
automatic
Engine size
2995 cc
Power
245 kW (333 HP)
Drive
AWD
Production
2015–2019

Factory service interval

The manufacturer specifies this for this version. Of the mileage and the time, the one that comes first is the one that counts.

  • Air filter

    • 60,000 km or 4 years
  • Cabin (pollen) filter

    • 30,000 km or 2 years
  • Engine oil and oil filter

    • LongLife30,000 km or 2 years(valid only with LongLife-approved oil)
    • 15,000 km or 1 year
  • Brake fluid change

    • first: 3 years, then 2 years(first change at 3 years, then every two years)
  • Coolant (antifreeze) change

    • first: 193,000 km or 10 years, then 97,000 km or 5 years(G13 / G12++: first change at 120,000 miles or 10 years, then every 60,000 miles or 5 years)
  • Spark plugs, petrol

    • 60,000 km or 6 years

Information, not an expert opinion

We write the descriptions, and we put the source next to them. A person reviews them before they go out. They are still information, not a technical expert opinion.

  • A fault on the list does not mean the car you are looking at has it.
  • A fault missing from the list does not mean the model is fault-free. Write-ups are made model by model. Not all of them are done.
  • You decide whether to buy. This is no substitute for an inspection. That needs a workshop and a history check.
Details in the terms