vinkodex.

Ford Transit Connect 200 L1 1.5 TDCI 75hp Ambiente common faults.

2013–2019, van, diesel, 75 HP.

The fault list covers: XUGA engine, IB6, MMT6, MTX75 transmission.

What you save stays on this device only. My saves

4 fault write-ups. All are important. No recall on the list.

If you know the year, pick it. Faults for other years drop out of the list.

Before you buy

Known faults

4 important faults

critical1

Door latch: the latching component breaks and the door can open while driving

critical

A component inside the door latch breaks, so the latch no longer holds properly: the door is hard to close, or it only catches on the first detent. The driver and the passenger may believe the door is properly shut when it is not, and it can open while driving.

Show the rest

Ford issued five campaigns between 2015 and 2023, and two of them, 20V331000 and 23V775000, recalled cars where the earlier repair had not been carried out properly. The 2020 campaign names six models: the 2011-2014 Fiesta, the 2012-2015 Focus, the 2013-2015 C-Max, the 2014-2016 Transit Connect, the 2015 Mustang and the 2013-2014 Fusion. The factory repair fits a revised door latch.

What to check

  • Close all four doors with normal force: none should need slamming, and none should bounce back
  • Push each door half shut: it must hold on the first detent, with no play
  • Open and close each one from the outside and the inside, including the child locks at the rear
2 more steps in the write-up

expensive3

MMT6 manual: worn shift mechanism, hard shifting when cold

expensive

The gearbox itself is reliable, but the shift mechanism wears noticeably between 100,000 and 150,000 km. Shifting becomes stiff, and it is most obvious when cold: the lever does not want to find its place, or the gear only goes in with force.

Show the rest

At high mileage the synchros on the first two gears wear out, and then the shift grates. The gearbox comes with a dual-mass flywheel, which is not the most durable part either.

between 100,000 and 150,000 km

What to check

  • Set off from cold: both first and second must engage without snagging
  • Stop and select reverse: it must not grate or need force
  • While rolling, change down into second: this is where worn synchros are audible
2 more steps in the write-up

IB6 manual: little oil, leaks, and the synchro noise that follows

expensive

The gearbox is light and compact and reliable, but the small oil quantity makes it sensitive to leaks: not much has to escape before the level becomes critical.

Show the rest

Most complaints about synchro noise actually come from this, from the low oil level rather than from the synchro itself. Beyond that the input shaft bearing can wear out and reverse can fail. Every version comes with a dual-mass flywheel, which is not the most durable part.

What to check

  • Look at the gearbox housing from underneath: fresh oil means a leak, and here that is the main cause
  • Ask when the oil level was last checked and whether it has ever been topped up
  • While rolling, change down into second and third: grating means worn synchros
2 more steps in the write-up

MTX75 manual: leaking seals, worn shafts

expensive

The gearbox itself is reliable and has two weak points. One is the input shaft bearing, which is short-lived, the other is the oil seals, which leak continuously.

Show the rest

The leak is the more dangerous one: any drop in the oil level wears the shafts and the gear rims, and that wear cannot be undone. Most versions come with a dual-mass flywheel, which is not the most durable part either.

What to check

  • Look at the bottom of the gearbox and where the driveshafts come out: fresh oil means a leak
  • Ask when the gearbox oil level was last checked, and ask for the invoice
  • At a steady speed, listen for noise: a worn input shaft bearing drones
2 more steps in the write-up

Checklist

Ford Transit Connect 200 L1 1.5 TDCI 75hp Ambiente

First what you would check on any car. Then the faults of this model.

Before you buy

Checklist

The printed sheet starts with what you would check on any car. What you tick stays on this device only.

On every car

Ask the owner

Faults of this model

vinkodex.com · Before you buy it, see what can go wrong.

Engine and transmission

1 engines · 3 transmissions

XUGA · 1.5 TDCI

55 kW (75 HP) · diesel

IB6 · 6-speed manual

manual · 6 speed

Torque limit285 Nm
MakerFord/Getrag

We built the code from the model and the gear count. The factory sheet does not state it. More than one transmission is possible. The gear count does not tell them apart. The code is on the side of the transmission.

Variant data

What is in this version

Factory data

Trim
200 L1 1.5 TDCI 75hp Ambiente
Body
van
Fuel
diesel
Transmission
manual
Engine size
1498 cc
Power
55 kW (75 HP)
Drive
FWD
Production
2013–2019

Factory service interval

The manufacturer specifies this for this version. Of the mileage and the time, the one that comes first is the one that counts.

  • Air filter

    • 60,000 km or 4 years

  • Cabin (pollen) filter

    • 30,000 km or 2 years

  • Brake fluid change

    • first: 3 years, then 2 years(first change at 3 years, then every two years)

  • Fuel filter, diesel

    • 60,000 km or 2 years
All Mk2 versions

Information, not an expert opinion

We write the descriptions, and we put the source next to them. A person reviews them before they go out. They are still information, not a technical expert opinion.

  • A fault on the list does not mean the car you are looking at has it.
  • A fault missing from the list does not mean the model is fault-free. Write-ups are made model by model. Not all of them are done.
  • You decide whether to buy. This is no substitute for an inspection. That needs a workshop and a history check.
Details in the terms