vinkodex.

Volkswagen Vento 1.9 SDI CL common faults.

1992–1998, saloon, diesel, 64 HP.

The fault list covers: AEY engine, MQ200 transmission.

What you save stays on this device only. My saves

3 fault write-ups. 2 important. 9 recalls.

If you know the year, pick it. Faults for other years drop out of the list.

Before you buy

Known faults

2 important faults

expensive2

MQ200 / MQ250 manual gearbox: differential bearing and synchros

expensive

The light, magnesium cased MQ200 and the MQ250, sized for higher torque, are the most widespread manual gearboxes in the transverse engine VAG models. Both have the same two weak points, and both depend on use.

Show the rest

The first is the differential bearing: as it wears you first get a droning, then a whine from the thrust bearings of the output shaft. Left alone, the planetary shaft can fail and in extreme cases punch through the gearbox casing: from then on it is not a repair but a replacement.

The second is the synchros: they can start crunching at around 50,000 km with aggressive driving. This type does not like dumping the clutch or slipping it, and on a used car that is exactly what you have to listen for.

above 50,000 km

What to check

  • On the test drive with the window down, listen to the gearbox both off and on the throttle: droning or whining is suspect
  • Shift up and down quickly, especially into 2nd and 3rd: crunching means synchro wear
  • Try engaging 1st and reverse when cold: resistance here means wear
2 more steps in the write-up

Stiff power steering

expensive

The steering moves with difficulty, with resistance and a quiet noise, and driving needs constant effort. The pump, the belt or the fluid level of the hydraulic power steering is behind it.

Show the rest

On a thirty year old car this is no surprise, but the repair is not negligible, and heavy steering can be a failure at the roadworthiness test too.

What to check

  • Standing still with the engine running, turn the wheel lock to lock
  • Listen to the pump: droning or groaning at full lock
  • Check the level and colour of the power steering fluid
1 more steps in the write-up

comfort1

Coolant temperature sensor (G62) failure

comfort

The G62 sensor tells the engine control unit how hot the coolant is. If it is faulty, the control unit thinks a warm engine is cold, and runs it rich: hard warm or cold starting, a rough idle, markedly increased fuel consumption, and a dash temperature gauge that jumps around or never reaches its usual reading. The part is cheap and can be replaced in half an hour: the trouble is that many people do not recognise it and replace an injector or a lambda sensor instead. If the fault persists, the rich mixture can destroy the catalytic converter too.

What to check

  • Warm it up and watch the dash temperature gauge: the needle should sit steadily at the middle reading, not jump around
  • Watch a cold start, then a warm start after twenty minutes standing
  • With a code reader look for the 17664 / P1256 code in the engine control unit
2 more steps in the write-up

Checklist

Volkswagen Vento 1.9 SDI CL

First what you would check on any car. Then the faults of this model.

Before you buy

Checklist

The printed sheet starts with what you would check on any car. What you tick stays on this device only.

On every car

Ask the owner

Faults of this model

vinkodex.com · Before you buy it, see what can go wrong.

Official recall9 recallsShow

The manufacturer fixes these for free at a franchised dealer. Ask with the VIN whether it was done.

Most recent: 23 April 2003

03V156000EQUIPMENT:OTHER:LABELSEQUIPMENT:OTHER:LABELS23 April 2003 · NHTSA (USA)

CERTAIN PASSENGER VEHICLES EQUIPPED WITH 2.8L VR6 ENGINES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 110, "TIRE SELECTION AND RIMS." THE RECOMMENDED COLD TIRE INFLATION PRESSURE PUBLISHED ON THE LABEL FOR TIRES OF THE SIZE 205/50 R15 86H IS 0.1 BAR (1.45 PSI) TOO LOW. IT SHOULD BE 2.5 BAR (36.3 PSI). THE LABEL RECOMMENDS 2.4 BAR (34.8 PSI = 35 PSI).

Risk: UNDER INFLATED TIRES CAN AFFECT VEHICLE HANDLING, AND DRIVING WITH SUBSTANTIALY UNDER INFLATED TIRES PUTS THE CONSUMER AT A RISK FOR A CRASH.

Remedy: OWNERS WILL BE PROVIDED WITH CORRECTED LABELS, OR A DEALER CAN INSTALL THE LABEL IF THE OWNER WISHES. OWNER NOTIFICATION BEGAN SEPTEMBER 29, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT VW AT 1-800-893-5298.

We could not check this: model year. The authority's notice

02V026000FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:FILLER PIPE AND CAPFUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:FILLER PIPE AND CAP25 January 2002 · NHTSA (USA)

ON SOME PASSENGER VEHICLES, THE FUEL TANK FILLER NECK CAN SUFFER ABRASION DAMAGE IF THE REAR TIRE GOES FLAT AND THE VEHICLE IS DRIVEN UNTIL THE TIRE DISINTEGRATES.

Risk: FUEL LEAKAGE CAN OCCUR INCREASING THE RISK OF A FIRE.

Remedy: DEALERS WILL FIT PASSAT VEHICLES WITH A NEW WHEEL HOUSE LINER THAT WILL BETTER PROTECT THE CAR'S FILLER NECK. JETTA VEHICLES WILL BE FITTED WITH A DIFFERENT METAL SHIELD DESIGNED TO ENHANCE ABRASION PROTECTION IN THE EVENT OF TIRE DISINTEGRATION. OWNER NOTIFICATION BEGAN JUNE 13, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT VOLKSWAGEN AT 1-800-822-8987.

We could not check this: model year. The authority's notice

98V195000SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGSSERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS17 August 1998 · NHTSA (USA)

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE REAR BRAKE LINE ON THE PASSENGER SIDE WAS ROUTED TOO CLOSE TO THE CORNER OF THE FUEL TANK. THE LINE COULD BE DAMAGED BY CHAFING AGAINST THE FUEL TANK.

Risk: REPEATED CHAFING COULD EVENTUALLY RESULT IN A LEAKING BRAKE LINE CAUSING DIMINISHED BRAKING IN ONE BRAKE CIRCUIT INCREASING THE VEHICLE'S STOPPING DISTANCE.

Remedy: DEALERS WILL INSPECT THE BRAKE LINE AND REPLACE ANY DAMAGED LINES.

We could not check this: model year. The authority's notice

98V160000LATCHES/LOCKS/LINKAGES:HOOD:LATCHLATCHES/LOCKS/LINKAGES:HOOD:LATCH16 July 1998 · NHTSA (USA)

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE BOLTS SECURING THE FRONT HOOD LATCH CAN LOOSEN OVER TIME. THE LATCH WOULD MOVE CAUSING DISENGAGEMENT OF THE HOOD STRIKER FROM THE LATCH.

Risk: UNEXPECTED OPENING OF THE HOOD COULD OCCUR OBSTRUCTING THE DRIVER'S VIEW OF THE ROAD WHILE DRIVING, INCREASING THE RISK OF A CRASH.

Remedy: DEALERS WILL INSPECT THE HOOD LATCH AND SECURING BOLTS AND REPLACE THEM IF NECESSARY.

We could not check this: model year. The authority's notice

96V128000VISIBILITY:POWER WINDOW DEVICES AND CONTROLSVISIBILITY:POWER WINDOW DEVICES AND CONTROLS8 July 1996 · NHTSA (USA)

THE SHEET METAL PANELS OF BOTH REAR DOORS HAVE OPENINGS FOR THE ROUTING OF THE ELECTRICAL WINDOW REGULATOR WIRING. THE PANEL OPENINGS HAVE SHARP EDGES THAT CAN DAMAGE THE INSULATION OF THE WIRING HARNESS.

Risk: AN ELECTRICAL SHORT IN THE WIRING CAN OCCUR RESULTING IN A POSSIBLE FIRE.

Remedy: DEALERS WILL INSTALL A PROTECTIVE EDGE COVER IN BOTH REAR DOOR INNER PANEL OPENINGS.

We could not check this: model year. The authority's notice

95V178000ENGINE AND ENGINE COOLING:COOLING SYSTEM:FANENGINE AND ENGINE COOLING:COOLING SYSTEM:FAN20 September 1995 · NHTSA (USA)

IMPROPER MATERIAL WAS USED IN MANUFACTURING THE RADIATOR FAN MOTOR SHAFT CAUSING THE SHAFT TO WEAR AND BECOME NOISY.

Risk: A WORN AND NOISY FAN MOTOR SHAFT CAN SEIZE RENDERINGTHE FAN MOTOR INOPERATIVE, EVENTUALLY CAUSING THE ENGINE TO OVERHEAT AND STALL. A STALLED VEHICLE IN TRAFFIC CAN INCREASE THE POTENTIAL FOR A VEHICLE ACCIDENT.

Remedy: DEALERS WILL REPLACE THE COMPLETE COOLING FAN ASSEMBLY ON VEHICLE HAVING THE POTENTIAL SHAFT MATERIAL PROBLEM. DEALERS WILL INSTALL A NEW FAN BLADE INCLUDING A NEW LOCK NUT ON VEHICLE WITH LOOSE FAN BLADE LOCK NUTS.

We could not check this: model year. The authority's notice

95V054000EQUIPMENT:MECHANICAL:ACCESSORY SCISSOR/SCREW/BOTTLE JACK/LIFTEQUIPMENT:MECHANICAL:ACCESSORY SCISSOR/SCREW/BOTTLE JACK/LIFT13 March 1995 · NHTSA (USA)

THE JACKS SUPPLIED WITH THESE VEHICLES WERE ASSEMBLED WITH AN IMPROPERLY MACHINED SPINDLE, SO THAT A SHARP RIDGE ON THE EDGE OF SPINDLE'S THREAD WOULD HAVE REMAINED.

Risk: THIS RIDGE CAN DAMAGE THE INSIDE THREAD OF THE JACK'S SCISSOR SHOE WHEN THE JACK IS USED TO LIFT THE VEHICLE. THE JACK COULD COLLAPSE WITH THE POSSIBILITY THAT A PERSON STANDING CLOSE TO THE VEHICLE COULD BE INJURED.

Remedy: OWNERS WILL BE PROVIDED WITH A NEW JACK.

We could not check this: model year. The authority's notice

92V131000VEHICLE SPEED CONTROLVEHICLE SPEED CONTROL15 September 1992 · NHTSA (USA)

THE VENTURI TUBE LOCATED IN THE THROTTLE VALVE HOUSING CAN BECOME LOOSE AND FALL AGAINST THE THROTTLE PLATE.

Risk: THE VENTURI TUBE CAN PARTIALLY BLOCK THE THROTTLE PLATEAND PREVENT IT FROM RETURNING TO ITS FULL IDLE POSITION, RESULTING IN UNWANTEDENGINE SPEED WHEN THE VEHICLE IS PLACED IN A FORWARD OR REVERSE GEAR.

Remedy: REPLACE THE PRESS-FIT VENTURI TUBE WITH A THREAD TYPE TUBE.

We could not check this: model year. The authority's notice

92V058000FUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGSFUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS14 April 1992 · NHTSA (USA)

THE FUEL HOSE ATTACHED TO THE FUEL DISTRIBUTION RAIL ON THE ENGINE MAY SHRINK BEYOND THE CLAMP FORCE OF THE FUEL HOSE CLAMPS, ALLOWING FUEL TO LEAK.

Risk: FUEL LEAKAGE IN THE ENGINE COMPARTMENT CAN CAUSE AN UNDERHOOD FIRE IF THE FUEL COMES IN CONTACT WITH A SOURCE OF IGNITION.

Remedy: REPLACE THE FUEL HOSE ATTACHED TO THE FUEL RAIL AND INSTALL A NEW SPRING TYPE SELF-TIGHTENING CLAMP.

We could not check this: model year. The authority's notice

Engine and transmission

AEY · 1.9 SDI

47 kW (64 HP) · diesel

MQ200 · 5- or 6-speed manual

manual · 5–6 speed

Torque limit200 Nm
MakerVolkswagen

We built the code from the model and the gear count. The factory sheet does not state it.

Variant data

What is in this version

Factory data

Trim
CL
Body
saloon
Fuel
diesel
Transmission
manual
Engine size
1896 cc
Power
47 kW (64 HP)
Drive
FWD
Production
1992–1998

Factory service interval

The manufacturer specifies this for this version. Of the mileage and the time, the one that comes first is the one that counts.

  • Air filter

    • 60,000 km or 4 years

  • Cabin (pollen) filter

    • 30,000 km or 2 years

  • Engine oil and oil filter

    • LongLife30,000 km or 2 years(valid only with LongLife-approved oil)
    • 15,000 km or 1 year

  • Brake fluid change

    • first: 3 years, then 2 years(first change at 3 years, then every two years)

  • Timing belt, 1.9 PD TDI

    • 130,000 km or 5 years(60,000 or 80,000 miles depending on the build year)

  • Coolant (antifreeze) change

    • first: 193,000 km or 10 years, then 97,000 km or 5 years(G13 / G12++: first change at 120,000 miles or 10 years, then every 60,000 miles or 5 years)

  • Fuel filter, diesel

    • 60,000 km or 2 years
All I versions

Information, not an expert opinion

We write the descriptions, and we put the source next to them. A person reviews them before they go out. They are still information, not a technical expert opinion.

  • A fault on the list does not mean the car you are looking at has it.
  • A fault missing from the list does not mean the model is fault-free. Write-ups are made model by model. Not all of them are done.
  • You decide whether to buy. This is no substitute for an inspection. That needs a workshop and a history check.
Details in the terms