vinkodex.

BMW X3 X3 M40d common faults.

2017–2021, SUV, diesel, 326 HP.

The fault list covers: B57D30T0 engine.

What you save stays on this device only. My saves

2 fault write-ups. Both are important. 14 recalls.

If you know the year, pick it. Faults for other years drop out of the list.

Before you buy

Known faults

2 important faults

critical1

B47 / B57 diesel: particulate filter and turbo on short trips

critical

The B47 replaced the N47, and the maker fixed the timing chain problem. The two remaining risks on this modern diesel depend on how the car was used.

Show the rest

The first is the particulate filter. On short urban trips the regeneration cannot finish, and the filter clogs. The second is the turbo. With extended oil change intervals its bearings wear.

On this engine the service history and the type of use tell you more than the odometer. On a 200,000 km car driven on motorways and serviced often, the filter and the turbo can be in better shape than on a 90,000 km city-only car.

Where turbo wear leads in the worst case: a runaway engine. If the turbo shaft seal fails, engine oil enters the intake on the compressor side. A diesel burns that too, and this is different from a petrol engine: a diesel controls torque with the quantity of fuel injected, and it has no throttle. Once the engine runs on its own oil, cutting the injection and switching off the ignition will not stop it. The revs climb on their own until the engine destroys itself for lack of lubrication.

If this happens while driving, turning the key does not help. The only thing that works is cutting off the air: cover or plug the intake, or discharge a dry powder extinguisher into the intake tract. On a manual car you can also stall it: hold the parking brake and the brake pedal, select a high gear, and release the clutch quickly so the drivetrain chokes the engine.

This is not common, and it can happen on any turbo diesel, not only on this engine. On this engine the turbo bearing and seal wear. The warning signs are blue smoke under acceleration, an unexplained drop in oil level, and an oily charge air pipe.

What to check

  • Ask how the car was used: short daily trips or longer runs?
  • Read the fault codes for particulate filter regeneration and differential pressure
  • On a longer test drive watch the power delivery and the smoke under load
5 more steps in the write-up

expensive1

XDrive transfer case (ATC): binding in corners, plastic actuator gear

expensive

The heart of the four wheel drive in the longitudinal engine BMW X models (X3, X5 and the X1 E84) is the ATC transfer case. It has two faults, and you can feel both while driving.

Show the rest

The first is wear of the clutch pack and the fluid: in a slow, tight corner (a car park, a roundabout) the car jerks and "hops", as if the drive grabbed and let go. You can also get a jerk when pulling away on a slope. The second is the plastic actuator gear: the position signal is lost, the brake, ABS and 4x4/DSC lights come on together on the dash, and a clicking is audible from the transfer case when you switch the ignition off.

Workshops often propose a full transfer case replacement straight away. But the plastic gear can be replaced on its own, and the wrong tyre size or a mixed set of tyres also imitates the jerking, because the transfer case then slips continuously. So clear up the tyres and the fault code first, before you pay for a transfer case replacement.

between 72,000 and 175,000 km

What to check

  • In a slow, tight corner (a car park) watch for jerking, binding and a "skipping" feel
  • When pulling away on light throttle, can you feel the drivetrain jerk
  • Watch the dash: 4x4, ABS, DSC and brake lights together point at the actuator
4 more steps in the write-up

Checklist

BMW X3 X3 M40d

First what you would check on any car. Then the faults of this model.

Before you buy

Checklist

The printed sheet starts with what you would check on any car. What you tick stays on this device only.

On every car

Ask the owner

Faults of this model

vinkodex.com · Before you buy it, see what can go wrong.

Official recall14 recallsShow

The manufacturer fixes these for free at a franchised dealer. Ask with the VIN whether it was done.

Most recent: 7 July 2026

SR/02180/26Safety recallFire7 July 2026 · EU Safety Gate

The RSW22 starter with reinforced water tightness (RWT) may experience increased abrasion of the magnetic contact, causing deposits to build up at the lowest point inside the relay. These deposits may increase relay contact resistance, leading to starting failures or short circuits. If a short circuit occurs, either when attempting to start the vehicle or while driving due to vibration-related movement of the deposits, it could cause a thermal event and increase the risk of fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: 07/07/2026

The authority's notice

SR/00551/26Safety recallFire30 January 2026 · EU Safety Gate

The failure concerns the RSW22 starter, type RWT (reinforced for watertightness). Increased abrasion of the magnetic contact can lead to the formation of deposits at the lowest point of the relay interior. This in turn can increase the resistance of the relay contact, causing accidental ignition or even short circuits, possibly leading to a thermal reaction and fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: 30/01/2026

The authority's notice

SR/00568/26Safety recallFire30 January 2026 · EU Safety Gate

The failure concerns the RSW22 starter, type RWT (reinforced for watertightness). Increased abrasion of the magnetic contact can lead to the formation of deposits at the lowest point of the relay interior. This in turn can increase the resistance of the relay contact, causing accidental ignition or even short circuits, possibly leading to a thermal reaction and fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: 30/01/2026

The authority's notice

SR/00584/26Safety recallFire30 January 2026 · EU Safety Gate

The failure concerns the RSW22 starter, type RWT (reinforced for watertightness). Increased abrasion of the magnetic contact can lead to the formation of deposits at the lowest point of the relay interior. This in turn can increase the resistance of the relay contact, causing accidental ignition or even short circuits, possibly leading to a thermal reaction and fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: 30/01/2026

The authority's notice

24V764000STRUCTURESTRUCTURE15 October 2024 · NHTSA (USA)

BMW of North America, LLC (BMW) is recalling certain 2018-2022 X3 sDrive30i, X3 xDrive30i, X3 M40i, and X3 M vehicles. The attachment for the rear cargo rail may become damaged in a rear crash and result in the cargo rail detaching.

Risk: Interior rear cargo rail detachment during a crash can increase the risk of injury.

Remedy: Dealers will replace the rear cargo rail attachment bolts, free of charge. Owner notification letters were mailed December 12, 2024. Owners may contact BMW customer service at 1-800-525-7417. Vehicles in this recall were previously remedied for this issue under recall number 24V-534 and will need to have the new repair completed.

The authority's notice

24V534000STRUCTURESTRUCTURE17 July 2024 · NHTSA (USA)

BMW of North America, LLC (BMW) is recalling certain 2018-2023 X3 sDrive30i, X3 xDrive30i, X3 M40i, and X3 M vehicles. The attachment for the interior cargo rail may become damaged in a rear crash and result in the cargo rail detaching.

Risk: Interior cargo rail detachment during a rear crash can increase the risk of injury.

Remedy: Dealers will replace the rear cargo rail attachment bolts, free of charge. Owner notification letters were mailed January 2, 2024. Owners may contact BMW customer service at 1-800-525-7417.

The authority's notice

20V443000BACK OVER PREVENTION: SENSING SYSTEM: CAMERABACK OVER PREVENTION: SENSING SYSTEM: CAMERA29 July 2020 · NHTSA (USA)

BMW of North America, LLC (BMW) is recalling certain 2020 X3 sDrive40i, X3 xDrive40i and X3M40i vehicles. These vehicles were not programmed with rearview camera software during assembly, therefore, when the transmission is shifted to reverse, a rearview image is not displayed. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rearview Mirrors."

Risk: An inoperative rearview camera display can increase the risk of a crash when reversing.

Remedy: BMW will notify owners, and dealers will program the affected vehicles with rearview camera software, free of charge. The recall began August 14, 2020. All vehicles have been remedied as of November 9, 2020. Owners may contact BMW customer service at 1-800-525-7417.

The authority's notice

A12/00600/21Safety recallInjuriesno date · EU Safety Gate

A battery insert (crash pad) has not been fitted. As a result, the battery would not be adequately secured tn the event of an accident, which could cause certain certain safety functions to become unavailable.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

A12/00636/20Safety recallInjuriesno date · EU Safety Gate

The cable connecting the hall sensor with the seat buckle might be too short. Consequently, the sensor might detach from the buckle, causing a faulty seatbelt lock recognition, impairing the functioning of the restraint system and the deployment of the airbag, increasing the risk of injury in the event of an accident.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

A12/00988/23Safety recallInjuriesno date · EU Safety Gate

The driver's and/or passenger's seat could break the frame rail that connects the seat to the guide rails on the vehicle floor. The stability of the seats may be affected, increasing the risk of injury in case of an accident. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

A12/01342/20Safety recallFireno date · EU Safety Gate

A short circuit in the high-voltage battery could occur during initial charging due to a particle in the form of a welding bead. This may trigger a chain reaction in the battery, increasing the risk of fire.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

A12/01377/22Safety recallFireno date · EU Safety Gate

Defects in the winding of cell-internal foils in the high-voltage batteries can lead to the occurrence of increased self-discharge. This can cause high voltage cell modules to overheat, increasing the risk of fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

A12/01824/20Safety recallInjuriesno date · EU Safety Gate

The safety belts for the driver and passenger seats may not have been fully bolted on. As a consequence, their restraining effect is not ensured in the event of an accident, increasing the risk of injury.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

A12/03084/24Safety recallInjuriesno date · EU Safety Gate

Due to faulty rear-most screws, the screw fixings of the boot's lashing rails can fail in the event of a rear-end collision with heavy intrusion and penetrate the backs of the rear seats. This increases the risk of injury to the occupants of the rear seats. The vehicles concerned have already been modified in connection with the recall code 0051960500. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

Engine and transmission

B57D30T0

240 kW (326 HP) · diesel

We built the code from the model and the gear count. The factory sheet does not state it.

Variant data

What is in this version

Factory data

Trim
X3 M40d
Body
SUV
Fuel
diesel
Transmission
automatic
Engine size
2993 cc
Power
240 kW (326 HP)
Drive
AWD
Production
2017–2021

Factory service interval

The manufacturer specifies this for this version. Of the mileage and the time, the one that comes first is the one that counts.

  • Air filter

    • 60,000 km or 4 years

  • Cabin (pollen) filter

    • 30,000 km or 2 years

  • Brake fluid change

    • first: 3 years, then 2 years(first change at 3 years, then every two years)

  • Engine oil and oil filter (BMW condition-based service)

    • LongLife25,000 km or 2 years

  • Fuel filter, diesel

    • 60,000 km or 2 years
All G01 versions

Information, not an expert opinion

We write the descriptions, and we put the source next to them. A person reviews them before they go out. They are still information, not a technical expert opinion.

  • A fault on the list does not mean the car you are looking at has it.
  • A fault missing from the list does not mean the model is fault-free. Write-ups are made model by model. Not all of them are done.
  • You decide whether to buy. This is no substitute for an inspection. That needs a workshop and a history check.
Details in the terms