BMW X4 X4 xDrive30d High Executive common faults.

2014–2018, SUV, diesel, 258 HP.

The fault list covers: N57D30 engine, ZF8HP70 transmission.

What you save stays on this device only. My saves

6 fault write-ups. All are important. 10 recalls.

If you know the year, pick it. Faults for other years drop out of the list.

Before you buy

Known faults

6 important faults

critical3

Diesel high pressure pump: power loss and engine shutdown while driving

critical

The high pressure pump of these common rail diesels (Bosch CP4) can fail while driving. The characteristic course is not gradual: a "Drivetrain fault" message appears on the dash, and within a few seconds the power is gone, on the motorway too. Afterwards the engine often cranks but will not start.

Show the rest

What makes the repair expensive: once the inside of the pump wears, metal debris travels through the rail and contaminates the entire fuel system. At that point replacing the pump is not enough: the injectors, the rails, the tank and the lines go with it. That is the difference between a "pump replacement" and a "full system replacement" quote, that is what you should ask about.

The maker started a recall for this in the United States (NHTSA 21V586000, 2014 to 2018 328d / X5 xDrive35d / 535d / 740Ld / X3 xDrive28d). The same campaign did not run in Europe, even though the same pump works in the 320d/520d/X3 20d versions that are common right across Europe. The recall does not cover these cars.

between 79,000 and 248,000 km

What to check

Ask whether there has ever been a "Drivetrain fault" message or a loss of power while driving
Ask for the service history: if the high pressure pump was replaced, check whether the injectors and the lines were replaced with it. If not, the debris may still be in the system
After a cold start listen to the engine at idle: irregular running or smoke is suspect

3 more steps in the write-up

N47 / N57 diesel: timing chain on the rear of the engine

critical

In these diesels BMW put the timing chain at the back of the engine, on the gearbox side. The chain, the guides and the tensioner wear early. The symptom is a metallic rattle on a cold start that quietens once warm.

Show the rest

The engine or the gearbox has to come out for the replacement, so the labour is a multiple of the parts cost. If the chain breaks or jumps, the engine is badly damaged inside, and the repair is an engine rebuild.

The problem is worst on engines built between March 2007 and March 2011, and the ones before early 2009 are the worst of all. The maker handled it under a service campaign in several European markets, but in the United Kingdom there was no formal recall. "It was never recalled" does not mean the chain is fine.

According to the German technical press the fault affects the whole N47 series and every power output, inspection is advised from 100,000 km, and factory revisions closed the matter around 2013, so cars built after 2013 are in a significantly better position. Stretching is typically preceded by a distinct rattle.

between 100,000 and 200,000 km

What to check

Insist on a cold start: the car should stand overnight, and the seller must not start it before you arrive
At the moment of starting, stand behind the engine (on the gearbox side) and listen to the first 3 to 5 seconds
A metallic rattle from the back of the engine calls for immediate expert inspection: this is not "diesel noise"

2 more steps in the write-up

Diesel EGR cooler: cracking, coolant in the intake, fire risk

critical

The internal fins of the exhaust gas recirculation cooler crack over time, and glycol coolant leaks into the intake, where it mixes with soot. The sticky mixture can ignite at high temperature: it can melt the plastic intake manifold and, in extreme cases, cause an engine bay fire.

Show the rest

The maker recalled the 2013 to 2018 four and six cylinder diesels, roughly 800,000 cars worldwide. The first repair attempt proved insufficient, and the leak returned in several cases: the cooler fitted since 2022, from a different supplier, is the valid fix.

So "the recall was carried out" is not enough on its own: you have to check when, and which repair was done. A first round repair does not by itself rule the problem out.

The early symptoms are white, sweet smelling exhaust smoke, slowly dropping coolant, and a rough idle.

It shows up on diesels built between 2013 and 2018. The earlier M57 is not covered by the recall.

between 108,000 and 222,000 km

What to check

Check the level in the expansion tank, and ask whether it has needed topping up
After a cold start watch the exhaust: persistent white smoke and a sweet smell mean the coolant is burning
Ask for the service book and find the EGR cooler recall entry: Check the date too

2 more steps in the write-up

expensive3

XDrive transfer case (ATC): binding in corners, plastic actuator gear

expensive

The heart of the four wheel drive in the longitudinal engine BMW X models (X3, X5 and the X1 E84) is the ATC transfer case. It has two faults, and you can feel both while driving.

Show the rest

The first is wear of the clutch pack and the fluid: in a slow, tight corner (a car park, a roundabout) the car jerks and "hops", as if the drive grabbed and let go. You can also get a jerk when pulling away on a slope. The second is the plastic actuator gear: the position signal is lost, the brake, ABS and 4x4/DSC lights come on together on the dash, and a clicking is audible from the transfer case when you switch the ignition off.

Workshops often propose a full transfer case replacement straight away. But the plastic gear can be replaced on its own, and the wrong tyre size or a mixed set of tyres also imitates the jerking, because the transfer case then slips continuously. So clear up the tyres and the fault code first, before you pay for a transfer case replacement.

between 72,000 and 175,000 km

What to check

In a slow, tight corner (a car park) watch for jerking, binding and a "skipping" feel
When pulling away on light throttle, can you feel the drivetrain jerk
Watch the dash: 4x4, ABS, DSC and brake lights together point at the actuator

4 more steps in the write-up

ZF 8HP automatic: mechatronics unit and connector sleeve leak

expensive

The ZF eight speed automatic (BMW Steptronic 8HP family) has two faults, and you can feel both.

Show the rest

The first is the mechatronics unit: the valve body and the control electronics in one. If the solenoids or the pressure regulation weaken, the gearbox jerks, the D/R engagement is delayed, it logs a gear ratio fault code, and finally drops into limp mode (often staying in 2nd or 3rd).

The second, and often misdiagnosed, is the connector sleeve of the mechatronics unit: the O-ring of the plastic sleeve ages, and ATF leaks from the side of the housing, exactly where the wiring harness enters. This is easy to mistake for a rear crankshaft seal. The trail starts from the driver's side of the housing, not from the clutch side.

On cars built in 2023 there was also a separate safety recall for a welding fault in the mechatronics unit. That is not the same as the wear related sleeve and the valves.

Check the fluid level, the area around the sleeve and the fault codes first; do not accept a "full gearbox replacement" quote straight away.

above 120,000 km

What to check

On the test drive watch for delayed D/R engagement, a jerk when shifting, and limp mode (a stuck gear)
Look at the driver's side of the gearbox housing where the wiring harness enters: an ATF trail from the sleeve is suspect
Do not confuse it with a rear crankshaft seal leak: the direction of the trail decides

3 more steps in the write-up

Undersized oil pump: lubrication runs out at the main and rod bearings

expensive

The connecting rod and main bearings run out, and the cause is the factory oil pump: it is undersized and does not deliver enough oil volume at idle and at low revs. BMW specifies 1.2 bar of oil pressure at idle at operating temperature, but on engines with mileage it falls below that, and the bearing shell is no longer adequately lubricated with that much. Bearing damage is reported between 130 000 and 200 000 kilometres, but it is always preceded by a longer period with low oil pressure.

Show the rest

The most important thing to know is that the control unit does not signal this: no lamp comes on for low oil pressure, and no fault code is stored either. The symptom is a quiet ticking at idle and a metallic noise under load, and at the rod bearing this is often explained by something else. It can be measured, though: a workshop connects a gauge and reads the real pressure at idle at operating temperature, and below 1.2 bar the engine is running in the period that causes the damage.

The length of the oil change decides matters on this engine. A change between 10 000 and 20 000 kilometres protects the bearing, the long factory interval does not. If the main bearing turns, the crankshaft is damaged too, and the upper half of the main bearing bed is aluminium while the lower is steel, so repairing the crankcase is difficult, and the block often goes out cracked and beyond repair. As prevention an uprated oil pump exists, with larger gears and its own pressure regulator, between 800 and 1150 euros, without fitting.

between 130,000 and 200,000 km

What to check

Have the oil pressure measured with a gauge at operating temperature at idle: below 1.2 bar is dangerous
Do not wait for a lamp or a fault code: the control unit does not signal this fault
Listen to the engine warm: a quiet ticking at idle, a metallic noise under load

3 more steps in the write-up

Official recall10 recallsShow

The manufacturer fixes these for free at a franchised dealer. Ask with the VIN whether it was done.

Most recent: 30 March 2023

A12/00868/23Safety recallInjuries30 March 2023 · EU Safety Gate

The airbag may deteriorate over time, and if deployed, excessive internal pressure may cause the inflator body to burst and metal fragments could pass through the cushion material causing injury to occupants. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: 30/03/2023

We could not check this: model year. The authority's notice

16V333000CHILD SEAT:LATCH STRAPCHILD SEAT:LATCH STRAP23 May 2016 · NHTSA (USA)

BMW of North America, LLC (BMW) is recalling certain model year 2011-2017, X3 sDrive28i, X3 xDrive28i and X3 xDrive35i, vehicles manufactured July 2, 2010 to April 14, 2016, 2015-2017 X3 xDrive28d vehicles manufactured March 10, 2014 to March 31, 2016, and 2015-2017 x4 xDrive28i, X4 xDrive35i and X4 xDriveM40i vehicles manufactured March3, 2014 to April 15, 2016. The affected vehicles have lower anchor bars for securing child restraint seats that may become damaged when using the European-ISOFIX-type, rigid-style connector, child restraint system.

Risk: Damaged lower anchor bars may increase the child's risk of injury in the event of a crash.

Remedy: BMW will notify owners, and dealers will weld a reinforcing bracket to the lower anchor bars and the vehicle body, free of charge. The recall began on July 13, 2016. Owners may contact BMW customer service at 1-800-525-7417.

We could not check this: model year. The authority's notice

14V648000VISIBILITY:REARVIEW MIRRORS/DEVICES:EXTERIORVISIBILITY:REARVIEW MIRRORS/DEVICES:EXTERIOR16 October 2014 · NHTSA (USA)

BMW of North America, LLC (BMW) is recalling certain model year 2015 X3 and X4 Sports Activity Vehicles manufactured July 28, 2014 to July 29, 2014. The affected vehicles may have been produced with a driver's side exterior rearview mirror that was designed to meet non-US market requirements. Thus, these vehicles fail to comply with the Federal Motor Vehicle Safety Standards No. 111, "Rearview Mirrors."

Risk: The driver may not notice that vehicles viewed in the mirror are closer than they appear, increasing the risk of a crash.

Remedy: BMW will notify owners, and dealers will replace the driver's side exterior rearview mirror, free of charge. The recall began on December 16, 2014. Owners may contact BMW customer service at 1-800-525-7417 or CustomerRelations@bmwusa.com.

We could not check this: model year. The authority's notice

A12/00608/20Safety recallInjuriesno date · EU Safety Gate

The screw connection from the passenger's airbag to the instrument panel may not have been manufactured according to specifications. As a result, if the airbag is activated, the panel cover may break into pieces, which will be propelled against the passenger increasing the risk of injury.