vinkodex.

Skoda Yeti 1.2 TSI 105hp Elegance common faults.

2014–2017, SUV, petrol, 105 HP.

The fault list covers: CBZB engine, DQ200 transmission.

What you save stays on this device only. My saves

6 fault write-ups. 3 important. 5 recalls.

If you know the year, pick it. Faults for other years drop out of the list.

Before you buy

Known faults

3 important faults

critical1

A few seconds of chain rattle on a cold start, later a permanent noise; the chain stretches and the tensioner does not hold it. If the chain jumps, the engine is badly damaged inside, and the repair is a rebuild. The tensioner is driven by oil pressure, so it does not hold with the engine stopped: a car left rolling in gear is the typical trigger for the chain jumping.

between 65,000 and 100,000 km

What to check

  • Start it cold, and in the first 2 to 3 seconds watch for the rattle from the chain side
  • Ask whether the chain and the tensioner have been replaced, and ask for the invoice
  • Check the oil change history in the service book: stretched intervals speed up the wear
1 more steps in the write-up

expensive2

A thin wall of the mechatronics valve body can crack, which causes a loss of pressure. The typical signs: jerking and harsh shifting from 1st to 2nd at low speed, a flashing PRNDS display, then a gear engagement fault, intermittently at first.

What to check

  • Pull away slowly from standstill and watch the 1 to 2 shift: does it jerk, is it harsh
  • Check whether the PRNDS display flashes or the dash reports a gearbox fault
  • In creep mode (brake released), does the car move off evenly
1 more steps in the write-up

With direct injection the fuel does not wash the intake valves: the petrol goes into the cylinder, not behind the valve. The oil mist and soot arriving through the EGR and the crankcase ventilation therefore build up on the valve stem and head, and from 80,000 to 100,000 km they restrict the flow. Symptoms are hesitation, loss of power, a rough cold start and misfire. It is not a part failure: it is a consequence of the design, and therefore it comes back. Cleaning (walnut or dry ice blasting) helps for a few tens of thousands of kilometres.

What to check

  • After a cold start watch the idle: rough running and shaking point to coked valves
  • Under load at low revs watch for hesitation
  • With a code reader look for per cylinder misfire (P0300 to P0304)
1 more steps in the write-up

cheap repair3

The dash shows "Error: Workshop! Only leave vehicle in position P" with an audible warning. The message appears in whatever language the car is set to, for example "Fehler: Werkstatt! Fahrzeug nur in Stellung P verlassen" in German.

Show the rest

The message points at the gearbox, but the fault is not there. A tiny switch sits in the module under the selector lever and signals that the lever is in park (P). Its contact wears and can also burn. That makes the signal unreliable, and the car warns you. The fault codes appear as 617752, P173400 or B116229.

At first it is intermittent. Sometimes the message comes up, sometimes not, so a short test drive easily misses it. Later it becomes permanent, and the gearbox can drop into limp mode.

This fault looks more expensive than it is. The maker released a separate retrofit switch kit for it (5Q0713128A for the black module, 3Q0713128 for the white one), which can be fitted in half an hour. The kit costs 70 to 100 pounds. At a franchised dealer, however, the whole selector lever module sometimes gets replaced, which costs 626 to 1,000 pounds there. So the difference between the two routes is roughly tenfold.

The affected group is post 2013 MQB platform Volkswagen, Audi, Seat and Skoda cars with a DSG gearbox. The switch is in these gearboxes, because that is what these cars have in common. The part itself is not part of the gearbox but of the module under the lever.

What to check

  • Watch the dash after starting: the message is intermittent and can be missed on a short loop
  • Move the lever from P to D and back several times, then get out and lock the car
  • Ask whether the selector lever switch has been replaced already, and ask for the invoice
2 more steps in the write-up

On some cars the control units do not go into sleep mode after the car is switched off, and the battery goes flat within days. The owner typically replaces the battery, and then the fault returns, because the battery is not the problem. The search starts with measuring the quiescent current, and the labour makes up the bigger part of the bill.

What to check

  • Ask specifically: has the car ever stood for a few days and then not started
  • Check whether a battery was replaced, and if so, how many times
  • After locking it, watch how long it takes for the onboard systems to go to sleep
1 more steps in the write-up

The tailgate responds with difficulty or not at all to the remote, sticks mechanically, or does not close properly. A tailgate that does not close also causes water ingress, and the boot electronics get wet.

What to check

  • Open and close the tailgate several times, with the remote and by hand
  • Watch whether it closes fully, or whether it has to be pressed
  • Look at the boot seal and the rust on the sill
1 more steps in the write-up

Checklist

Skoda Yeti 1.2 TSI 105hp Elegance

First what you would check on any car. Then the faults of this model.

Before you buy

Checklist

The printed sheet starts with what you would check on any car. What you tick stays on this device only.

On every car

Ask the owner

vinkodex.com · Before you buy it, see what can go wrong.

Official recall5 recallsShow

The manufacturer fixes these for free at a franchised dealer. Ask with the VIN whether it was done.

Most recent: 1 June 2026

SR/01853/26Safety recallInjuries1 June 2026 · EU Safety Gate

The propellant in the driver airbag may deteriorate over time. If the airbags deploy, it could result in fragments from the inflator injuring the vehicle's occupants. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: 01/06/2026 Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Request to stop driving Date of entry into force: Unknown

We could not check this: model year. The authority's notice

A12/0893/17Safety recallInjuries22 June 2017 · EU Safety Gate

Due to a faulty connection, parts of the front-seat belts tensioners could become detached on deployment in an accident and enter the vehicle interior, putting the occupants at risk of injury.

Remedy: Type of economic operator to whom the measure(s) were ordered: Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: 22/06/2017

We could not check this: model year. The authority's notice

A12/00787/23Safety recallInjuriesno date · EU Safety Gate

The airbag may deteriorate over time and if deployed, excessive internal pressure may cause the inflator body to burst and metal fragments could pass through the cushion material causing injury to occupants. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

A12/1689/19Safety recallInjuriesno date · EU Safety Gate

The screws on the camshaft adjuster may become loose. As a result, engine oil will leak onto the road, posing a risk to the following traffic.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

SR/00680/26Safety recallInjuriesno date · EU Safety Gate

A defect in the inflator of the driver airbag may cause uncontrolled inflation and the release of metal fragments when the airbag is activated, causing injury to the occupants. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Importer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

We could not check this: model year. The authority's notice

Engine and transmission

CBZB · 1.2 TFSI

77 kW (105 HP) · petrol

DQ200 · 7-speed DSG, dry clutch

DSG · 7 speed

Clutchdry
Torque limit250 Nm
MakerVolkswagen

We built the code from the model and the gear count. The factory sheet does not state it.

Variant data

What is in this version

Factory data

Trim
Elegance
Body
SUV
Fuel
petrol
Transmission
automatic
Engine size
1197 cc
Power
77 kW (105 HP)
Drive
FWD
Production
2014–2017

Factory service interval

The manufacturer specifies this for this version. Of the mileage and the time, the one that comes first is the one that counts.

  • Air filter

    • 60,000 km or 4 years
  • DQ200: lifetime fill by the maker, not in practice

    • lifetime fill: the maker does NOT specify a change
  • Cabin (pollen) filter

    • 30,000 km or 2 years
  • Engine oil and oil filter

    • LongLife30,000 km or 2 years(valid only with LongLife-approved oil)
    • 15,000 km or 1 year
  • Brake fluid change

    • first: 3 years, then 2 years(first change at 3 years, then every two years)
  • Coolant (antifreeze) change

    • first: 193,000 km or 10 years, then 97,000 km or 5 years(G13 / G12++: first change at 120,000 miles or 10 years, then every 60,000 miles or 5 years)
  • Spark plugs, petrol

    • 60,000 km or 6 years

Information, not an expert opinion

We write the descriptions, and we put the source next to them. A person reviews them before they go out. They are still information, not a technical expert opinion.

  • A fault on the list does not mean the car you are looking at has it.
  • A fault missing from the list does not mean the model is fault-free. Write-ups are made model by model. Not all of them are done.
  • You decide whether to buy. This is no substitute for an inspection. That needs a workshop and a history check.
Details in the terms