Volkswagen Golf VII.5 common faults.

Volkswagen Group of America, Inc. (Volkswagen) is recalling two 2018 Golf GTI vehicles. The VIN printed on the Federal Certification label may not match the actual VIN on the vehicle. As such, these vehicles fail to comply with the requirements of 49 CFR Part 567, "Certification."

Risk: If the stamped vehicle identification number (VIN) does not match the VIN on the Vehicle Certification Label, owners may be unable to tell if their vehicle is under an important safety recall, possibly exposing them to an increased risk of a crash, fire or injury.

Remedy: Volkswagen will notify owners, and dealers will install a correct certification label, free of charge. This recall began July 9, 2020. Owners may contact Volkswagen customer service at 1-800-893-5298. Volkswagen's number for this recall is 01E7.

The authority's notice

Defective material may be used in the rear suspension helical springs. As a result, the springs could break, impairing the driving stability and increasing the risk of an accident. The product does not comply with the requirements laid down in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles

Remedy: Type of economic operator taking notified measure(s): Importer Category of measure(s): Recall of the product from end users Date of entry into force: 13/05/2019

The authority's notice

Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2015-2018 Volkswagen Golf and Golf Sportwagen vehicles. The build of silicate on the shift lever micro switch contacts may enable the key to be removed from the ignition while the vehicle shift lever is not in "Park." As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 114, "Theft Protection and Rollaway Prevention."

Risk: Removing the key while the shift lever is in a position other than "Park" increases the risk of an unintended vehicle rollaway that may result in personal injury or a crash.

Remedy: Volkswagen will notify owners, and dealers will install an additional switch and circuit board, free of charge. The recall began March 19, 2019. Owners may contact Volkswagen customer service at 1-800-893-5298. Volkswagen's number for this recall is 37L5.

The authority's notice

The thermal protection between the brake force booster and the emissions control device in front of the coupling support with the brake fluid reservoir may not have been correctly fitted. The coupling support could melt, leading to a leak of brake fluid, which could ignite if it comes into contact with hot components. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

Cars initially used for internal purposes of Volkswagen AG might not have been correctly modified before they were sold to the general public. There is a possibility that certain safety systems of these cars are not correctly modified for street use.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

Due to a manufacturing error, the brake-pedal plate may not have been adequately welded and could become completely detached when the brake pedal is suddenly applied. As a result, the application of the brakes will be impaired, increasing the risk of an accident.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

The amount of extinguishing sand in the fuse of the high-voltage system is not sufficient in the event of a short circuit to the high-voltage safety system. This may cause it to burst, increasing the risk of injuries. Furthermore, the blown fuse can interrupt electrical flow of current leading to a voltage drop inside the vehicle, increasing the risk of fire. The product does not comply with the Regulation on the approval and market surveillance of Motor Vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

The engine covers installed on affected vehicles could detach from their fixings depending on the conditions of use (e.g. very sporty driving, or poor road surfaces) and their age. A loose engine cover could come into contact with the hot area of the exhaust gas turbocharger, increasing the risk of burns or fire. The product does not comply with the Regulation on the approval and market surveillance of Motor Vehicles and their trailers, and of systems, components and separate technical units intended for such vehicle.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

The emergency call service may not be functioning. As a result, the system may not assist the car occupants by contacting the call centre/rescue coordination centre in the event of an accident.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

The luggage net may be incorrectly affixed. As a result, luggage could end up in the passenger compartment, causing injury to the occupants.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

The propellant in the driver airbag may deteriorate over time. If the airbags deploy, it can result in fragments from the inflator injuring the vehicle's occupants. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

Some vehicles have differences in the mixture ratio for the initiating device, which could lead to the driver and passenger airbag or seat-belt pre-tensioner not activating in the event of an accident.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

The brake discs on the front axle are too weak. As a consequence, when placed under extreme pressure, the brake disc can crack or even break, affecting braking performance.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

The fastening of the active headrest may be defective. In the event of an accident, the headrest may become detached from the back of the seat, increasing the risk of injury to the person occupying the seat.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

The car has tyre-pressure signs/stickers indicating the incorrect tyre pressure requirement. Too low tyre pressure may cause the tread to separate or the tyre to burst.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

The rear wheel-bearing housing may fracture. This can impair the vehicle’s road-holding ability, leading to the risk of an accident.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

The fitting for the headrest may have been incorrectly welded to the backrest. As a consequence, the supportive and protective effect of the headrest may be limited in the event of an accident.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

Faulty crash sensors for the airbag restraint systems may have been installed in the doors. This could impair the protective effect of the side airbags, head airbags and/or belt tensioners, increasing the risk of injury in the event of an accident.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice

The propellant in the driver airbag may deteriorate over time. If the airbags deploy, it can result in fragments from the inflator injuring the vehicle's occupants. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Remedy: Type of economic operator taking notified measure(s): Manufacturer Category of measure(s): Recall of the product from end users Date of entry into force: Unknown

The authority's notice